MTCMR-G-F4 Multi-Tech Systems, MTCMR-G-F4 Datasheet - Page 162

• Manufacturer Part Number: MTCMR-G-F4
• Description: MODEM GPRS QUAD BAND GSM GLOBAL
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® iCellr

Specifications of MTCMR-G-F4

• Frequency: 850MHz, 900MHz, 1.8GHz, 1.9GHz
• Applications: General Purpose
• Interface: RS-232, USB
• Function: Transceiver, Modem
• Data Rate - Maximum: 115.2kbps
• Modulation Or Protocol: GSM, GPRS
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module with Case
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Power - Output: -
• Sensitivity: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 881-1151; MTCMR-G-F4

Request GPRS IP Service D
Multi-Tech Systems, Inc. GPRS AT Commands Reference Guide (Document Number S000293J)
Description:
Values:
Syntax:
Example:
This command causes the modem to perform whatever actions are necessary to establish
communication between the DTE and the external PDN.
The V.25ter 'D' (Dial) command causes the modem to enter the V.25ter online data state and, with the
DTE, to start the specified layer 2 protocol. The modem returns CONNECT to confirm acceptance of the
command prior to entering the V.25ter online data state. No further commands may follow on the AT
command line.
The detailed behavior after the online data state has been entered is described briefly in clause 9, for
IP, of GSM 07.60. GPRS attachment and PDP context activation procedures may take place prior to or
during the PDP startup if they have not already been performed using the +CGATT and +CGACT
commands.
If <cid> is supported, its usage is the same as in the +CGDATA command. The +CGDCONT,
+CGQREQ, etc. commands may then be used in the modem initialization AT command string to set
values for for PDP type, APN, QoS etc.
If <cid> is not supported or is supported but omitted, the modem attempt to activate the context using
the 'Empty PDP type' (GSM 04.08). (No PDP address or APN is sent in this case and only one PDP
context subscription record is present in the HLR for this subscriber.)
Note: If a GPRS PPP session is already running, the setting of a CSD (GSM data call) is not supported.
<GPRS_SC_IP>
<cid>
Command Syntax:
ATD*99***1#
CONNECT
ATD*99***2#
ERROR
Command
D*<GPRS_SC_IP>[***<cid>]#
(GPRS Service Code for IP) a digit string (value 99), which identifies a request to
A digit string which specifies a particular PDP context definition.
use the GPRS with IP (PDP types IP and PPP)
Possible Responses
CONNECT
ERROR
Chapter 15 – GPRS Commands
162