SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 38

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

Command description
D.26.2
D.27
D.27.1
D.27.2
D.28
D.28.1
D.28.2
38/50
to bypass mode. [Interval] 1-1000 is the number of 100ms intervals (0.1sec to 100 sec)
between page attempts. This interval is in addition to the amount of time required by the
page attempt itself.
Responses
If the operation is successful, the response is:
AT-AB SmartCableConfigDone
SPPConnect
The SPPConnect command is used to initiate a connection with the specified device. The
remote BD address must be specified. The remote Service is optional. If not specified, the
first registered SPP service will be used by default.
Syntax
AT+AB SPPConnect [BD Addr] [Service]
Where [BD Addr] is the remote devices BD Address to page. [Service] is the specific
service on the remote device; parameter is optional.
Responses
If the connection is successful, the response is:
AT-AB ConnectionUp
AT-AB -BypassMode-
If the connection cannot be completed, the response is:
AT-AB SPPConnectionClosed
SPPDisconnect
The SPPDisconnect command is used to terminate a connection with the remote device.
Syntax
AT+AB SPPDisconnect
Responses
If the connection is successful, the response is
AT-AB SPPConnectionClosed
Doc ID 16089 Rev 7
SPBT2532C2.AT