PC28F256J3F95A NUMONYX, PC28F256J3F95A Datasheet - Page 25

• Manufacturer Part Number: PC28F256J3F95A
• Description: IC FLASH 256MBIT 95NS 64EZBGA
• Manufacturer: NUMONYX
• Series: StrataFlash™r

Specifications of PC28F256J3F95A

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 256M (32M x8, 16M x16)
• Speed: 95ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TBGA
• Cell Type: NOR
• Density: 256Mb
• Access Time (max): 95ns
• Interface Type: Parallel
• Address Bus: 25/24Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: EZBGA
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 32M/16M
• Supply Current: 31mA
• Mounting: Surface Mount
• Pin Count: 64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 898244; 898244; PC28F256J3F95 898244

Numonyx™ StrataFlash
Note:
8.3
December 2008
319942-02
Programming Confirm command is written to the device, a command sequence error
occurs and SR[7,5,4] are set. If an error occurs while writing to the array, the device
stops programming, and SR[7,4] are set, indicating a programming failure.
When Buffered Programming has completed, additional buffer writes can be initiated by
issuing another Buffered Programming Setup command and repeating the buffered
program sequence.
If an attempt is made to program past an erase-block boundary using the Buffered
Program command, the device aborts the operation. This generates a command
sequence error, and SR[5,4] are set.
If Buffered programming is attempted while VPEN is below V
any errors are detected that have set Status Register bits, the Status Register should
be cleared using the Clear Status Register command.
In x8 mode, a maximum of 256 bytes of data can be loaded into the write buffer as N
can have a max value of FFh.
Suspend/Resume
An erase or programming operation can be suspended to perform other operations, and
then subsequently resumed. Please refer to
details.
®
Embedded Memory (J3-65nm)
Chapter 9.0, “Suspend/Resume”
PENLK
, SR[4,3] are set. If
for
Datasheet
25