M25P80-VMN6P NUMONYX, M25P80-VMN6P Datasheet - Page 10

• Manufacturer Part Number: M25P80-VMN6P
• Description: MEMORY, FLASH, SERIAL, 8MB, 8NSOIC
• Manufacturer: NUMONYX

Specifications of M25P80-VMN6P

• Memory Size: 8Mbit
• Clock Frequency: 75MHz
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: NSOIC
• No. Of Pins: 8
• Operating Temperature Range: -40°C To +85°C
• Package / Case: NSOIC
• Memory Type: Flash
• Memory Configuration: 1M X 8
• Interface Type: Serial, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3
Figure 3.
1. The Write Protect (W) and Hold (HOLD) signals should be driven, High or Low as appropriate.
10/57
SPI Interface with
(CPOL, CPHA) =
CS3
(0, 0) or (1, 1)
SPI Bus Master
SPI modes
These devices can be driven by a microcontroller with its SPI peripheral running in either of
the two following modes:
For these two modes, input data is latched in on the rising edge of Serial Clock (C), and
output data is available from the falling edge of Serial Clock (C).
The difference between the two modes, as shown in
bus master is in Standby mode and not transferring data:
Bus Master and memory devices on the SPI bus
Figure 3
one device is selected at a time, so only one device drives the Serial Data Output (Q) line at
a time, the other devices are high impedance. Resistors R (represented in
that the M25P80 is not selected if the Bus Master leaves the S line in the high impedance
state. As the Bus Master may enter a state where all inputs/outputs are in high impedance at
the same time (for example, when the Bus Master is reset), the clock line (C) must be
connected to an external pull-down resistor so that, when all inputs/outputs become high
impedance, the S line is pulled High while the C line is pulled Low (thus ensuring that S and
C do not become High at the same time, and so, that the t
typical value of R is 100K Ω, assuming that the time constant R*C
capacitance of the bus line) is shorter than the time during which the Bus Master leaves the
SPI bus in high impedance.
CS2 CS1
CPOL=0, CPHA=0
CPOL=1, CPHA=1
C remains at 0 for (CPOL=0, CPHA=0)
C remains at 1 for (CPOL=1, CPHA=1)
shows an example of three devices connected to an MCU, on an SPI bus. Only
SDO
SDI
SCK
R
R
C Q D
S
SPI Memory
Device
W
V
CC
HOLD
V
R
SS
C Q D
S
SPI Memory
Device
Figure
W
V
HOLD
CC
SHCH
V
4, is the clock polarity when the
R
SS
requirement is met). The
p
C Q D
S
(C
SPI Memory
p
Device
= parasitic
W
Figure
V
CC
HOLD
AI12836b
V
SS
3) ensure
V
V
CC
SS