M25P80-VMN6P NUMONYX, M25P80-VMN6P Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/4/484/numonyx_sml.jpg)
M25P80-VMN6P
Manufacturer Part Number
M25P80-VMN6P
Description
MEMORY, FLASH, SERIAL, 8MB, 8NSOIC
Manufacturer
NUMONYX
Datasheet
1.M25P80-VMP6G.pdf
(57 pages)
Specifications of M25P80-VMN6P
Memory Size
8Mbit
Clock Frequency
75MHz
Supply Voltage Range
2.7V To 3.6V
Memory Case Style
NSOIC
No. Of Pins
8
Operating Temperature Range
-40°C To +85°C
Package / Case
NSOIC
Memory Type
Flash
Memory Configuration
1M X 8
Interface Type
Serial, SPI
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M25P80-VMN6P
Manufacturer:
MICRON
Quantity:
20 000
Part Number:
M25P80-VMN6PBA
Manufacturer:
ST
Quantity:
20 000
2
2.1
2.2
2.3
2.4
2.5
2.6
8/57
Signal description
Serial Data output (Q)
This output signal is used to transfer data serially out of the device. Data is shifted out on the
falling edge of Serial Clock (C).
Serial Data input (D)
This input signal is used to transfer data serially into the device. It receives instructions,
addresses, and the data to be programmed. Values are latched on the rising edge of Serial
Clock (C).
Serial Clock (C)
This input signal provides the timing of the serial interface. Instructions, addresses, or data
present at Serial Data Input (D) are latched on the rising edge of Serial Clock (C). Data on
Serial Data Output (Q) changes after the falling edge of Serial Clock (C).
Chip Select (S)
When this input signal is High, the device is deselected and Serial Data Output (Q) is at high
impedance. Unless an internal Program, Erase or Write Status Register cycle is in progress,
the device will be in the Standby mode (this is not the Deep Power-down mode). Driving
Chip Select (S) Low enables the device, placing it in the active power mode.
After Power-up, a falling edge on Chip Select (S) is required prior to the start of any
instruction.
Hold (HOLD)
The Hold (HOLD) signal is used to pause any serial communications with the device without
deselecting the device.
During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data
Input (D) and Serial Clock (C) are Don’t Care.
To start the Hold condition, the device must be selected, with Chip Select (S) driven Low.
Write Protect (W)
The main purpose of this input signal is to freeze the size of the area of memory that is
protected against program or erase instructions (as specified by the values in the BP2, BP1
and BP0 bits of the Status Register).