C200H-CN222 Omron, C200H-CN222 Datasheet - Page 77

• Manufacturer Part Number: C200H-CN222
• Description: CPM1A/CPM2A CABLE
• Manufacturer: Omron

Specifications of C200H-CN222

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Inspection and Maintenance
Batteries
1, 2, 3...
Battery
connector
Battery Set
Some RAM Packs use a battery (refer to Appendix B for specifications). When
the battery is nearly discharged, the ALARM indicator blinks and the message
“BATT FAIL” appears on the Programming Console. When this occurs, replace
the battery within one week to avoid loss of data. The battery comes together
with its connector as a set. To replace the Battery Set, follow the steps below.
The entire replacement must be completed within five minutes to ensure that the
data will not be lost.
If you are using model C200H-CPU11-E as the CPU, the battery is installed in
the Unit upon delivery.
1. Turn OFF the power to the PC. (If the power was not already ON, turn the
2. Remove the cover from the battery compartment of the RAM Pack.
3. Remove the old Battery Set.
4. Install the new Battery Set as shown shown in the following diagram.
5. Replace the cover of the battery compartment.
6. Press CLR, FUN, MONTR, MONTR or just turn the power to the PC OFF
power ON for at least one minute before turning the power OFF.)
and then ON again to clear the error message on the Programming Con-
sole.
Appendix A
63