MINILINK Neutrik, MINILINK Datasheet - Page 11

• Manufacturer Part Number: MINILINK
• Description: SIGNAL GENERATOR, MINILINK, UK
• Manufacturer: Neutrik

Specifications of MINILINK

• Signal Generator Type: Signal
• Svhc: No SVHC (18-Jun-2010)

MiniLINK PC Software Installation
a. Switch on the PC with a windows operating system (MiniLINK supports
b. Insert the enclosed MiniLINK CD into the CD drive.
c. The MiniLINK software installation starts automatically. Follow the
d. Use the attached USB cable to connect the test instrument to the PC.
After completing the software installation, the MiniLINK CD shall remain
Note:
Windows 98 SE, 2000, ME and XP)
instructions on the screen.
If the CD auto-start is disabled on the PC, follow the instructions below:
•
•
•
in the CD drive for the next step.
Windows recognizes the new hardware component automatically and
starts the hardware installation assistant.
Follow the instructions of the installation assistant. Please select the
CD drive as source for the USB driver when asked by the installation
assistant.
In case the warning messages “Digital signature not found”, “Do not
install driver”, “not certified driver” or similar come up: Don’t listen to
Microsoft, listen to us and continue with the installation.
Click on “Start -> Run“ at the windows taskbar.
Type “d:\setup“ (assuming “d“ is the letter of the CD drive)
Confirm with “ok“
If the MiniLINK PC software has been previously installed
on the PC, the old version will automatically be removed.
You need to run the set up program again for a new
installation.
11