IP20 SOLA HEVI DUTY, IP20 Datasheet - Page 37

• Manufacturer Part Number: IP20
• Description: Fuse Cover Kit
• Manufacturer: SOLA HEVI DUTY

Specifications of IP20

• Peak Reflow Compatible (260 C): No
• Kit Contents: 2 Covers And Thread Forming Screws
• Leaded Process Compatible: No
• For Use With: SBE Fuse Block
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 4
Table 5
Fault and LEDs D&E are
Illuminated
Battery LED is flashing.
Condition
Battery Mode (mains failure)
Low Battery
Output Overload (Bypass)
Overtemperature (Bypass)
DC Bus Overvoltage (Bypass)
DC-DC failure during battery
mode
PFC Failure (Bypass)
Inverter Failure
Battery Test Failure
Fan Locked
REPO Active
UPS OFF; Autorestart disabled
from previous REPO shutdown
Charger Malfunction
Problem
Troubleshooting guide (cont’d)
Alarm conditions
Cause
Charger malfunction
Battery source is not
available; continuous horn.
Alarm
One short beep every 10 seconds: more than 2 minutes of run time remaining
Two short beeps every 5 seconds: less than 2 minutes of run time remaining
One short beep every half second
A one-second beep every 4 seconds
A one-second beep every 4 seconds
A one-second beep every 4 seconds
A one-second beep every 4 seconds
A one-second beep every 4 seconds
A two-second beep every 1 minute
A one-second beep every 4 seconds
A 0.25-second beep every 0.25 seconds
A one-second beep every 4 seconds
A one-second beep every 4 seconds
31
Solution
If the charger is overvoltage, the UPS will shutdown. If the
charger is undervoltage and the batteries are nearly depleted,
this alarm will give a temporary warning before the UPS shuts
down. UPS requires service. Contact your local dealer, Sola/
Hevi-Duty representative or Sola/Hevi-Duty Technical Support
Services.
Check battery connections, completely power down and restart
UPS.
NOTE: If the battery circuit
opens while the UPS is running,
it will be detected when the next
battery test is performed.
Troubleshooting