LAN91C96I-MU SMSC, LAN91C96I-MU Datasheet - Page 47

• Manufacturer Part Number: LAN91C96I-MU
• Description: Ethernet ICs Non-PCI 10 Mbps Ethernet MAC
• Manufacturer: SMSC
• Type: Single Chip MAC and PHY Controllerr

Specifications of LAN91C96I-MU

• Ethernet Connection Type: 10 Base-T, 100 Base-TX
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: 802.3, 802.3u
• Data Rate: 10 Mbps, 100 Mbps
• Supply Voltage (max): 5 V
• Supply Voltage (min): 0 V
• Supply Current (max): 95 mA
• Maximum Operating Temperature: + 70 C
• Package / Case: TQFP-100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Non-PCI Single-Chip Full Duplex Ethernet Controller with Magic Packet
Datasheet
SMSC LAN91C96 5v&3v
FILT_CAR - Filter Carrier. When set filters leading edge of carrier sense for 12 bit times. Otherwise
recognizes a receive frame as soon as carrier sense is active.
STRIP_CRC - When set it strips the CRC on received frames. When clear the CRC is stored in memory
following the packet. Defaults low.
RXEN - Enables the receiver when set. If cleared, completes receiving current frame and then goes idle.
Defaults low on reset.
ALMUL - When set accepts all multicast frames (frames in which the first bit of DA is '1'). When clear
accepts only the multicast frames that match the multicast table setting. Defaults low.
PRMS - Promiscuous mode. When set receives all frames.
Change vs. LAN91C92: Does not receive its own transmission when not in full duplex(FDUPLX)!.
RX_ABORT - This bit is set if a receive frame was aborted due to length longer than 1532 bytes. The
frame will not be received. The bit is cleared by RESET or by the CPU writing it low.
I/O SPACE - BANK0
Counts four parameters for MAC statistics. When any counter reaches 15 an interrupt is issued. All
counters are cleared when reading the register, and do not wrap around beyond 15.
Each four bit counter is incremented every time the corresponding event, as defined in the EPH STATUS
REGISTER bit description, occurs. Note that the counters can only increment once per enqueued transmit
packet, never faster, limiting the rate of interrupts that can be generated by the counters. For example if a
packet is successfully transmitted after one collision the SINGLE COLLISION COUNT field is incremented
by one. If a packet experiences between 2 to 16 collisions, the MULTIPLE COLLISION COUNT field is
incremented by one.
If a packet experiences deferral the NUMBER OF DEFERRED TX field is incremented by one, even if the
packet experienced multiple deferrals during its collision retries.
The COUNTER REGISTER facilitates maintaining statistics in the AUTO RELEASE mode where no
transmit interrupts are generated on successful transmissions.
Reading the register in the transmit service routine will be enough to maintain statistics.
OFFSET
0
0
NUMBER OF EXC. DEFERRED TX
6
MULTIPLE COLLISION COUNT
0
0
COUNTER REGISTER
0
0
DATASHEET
NAME
0
0
Page 47
0
0
NUMBER OF DEFERRED TX
SINGLE COLLISION COUNT
READ ONLY
TYPE
0
0
0
0
SYMBOL
ECR
Revision 1.0 (10-24-08)
0
0