10070D AGILENT TECHNOLOGIES, 10070D Datasheet - Page 23

• Manufacturer Part Number: 10070D
• Description: OSCILLOSCOPE PROBE, 1:1, 20MHZ
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 10070D

• Test Probe Type: Oscilloscope
• Test Probe Functions: Frequency
• For Use With: Infiniium 8000 Series Oscilloscopes
• Lead Free Status / RoHS Status: na

Infiniium Performance Characteristics
Trigger: scope channels
Sensitivity
Level range
Sweep modes
Trigger coupling
Trigger conditioning
Trigger holdoff range
Trigger jitter
Trigger actions
Trigger modes
Violation triggers
Internal
Auxiliary
Internal
Auxiliary
Edge
Glitch
Line
Pattern
State
Delay by time
Delay by events
TV
Pulse width
Setup/hold
Transition
6
DSO8064A, MSO8064A, DSO8104A, MSO8104A
DC to 600 MHz: 0.6 div
600 MHz to 1 GHz: 1.5 div (50 Ω)
DC to 600 MHz: 300 mVp-p
± 8 div from center screen (1 MΩ)
± 8 div from center screen (50 Ω)
± 5 V
Auto, triggered, single
DC, AC, low frequency reject (50 kHz high pass filter), high frequency reject
(50 kHz low pass filter)
Noise reject adds hysteresis to trigger circuitry decreasing sensitivity to noise
50 ns to 10 s
8 ps ± 0.05 ppm x |delay setting| rms
Specify an action to occur, and the frequency of the action, when a trigger condition occurs.
Actions include: e-mail on trigger and QuickMeas+ functions
Triggers on a specified slope and voltage level on any channel, auxiliary trigger or line input.
Triggers on glitches narrower than the other pulses in your waveform by specifying a width
less than your narrowest pulse and a polarity. Minimum glitch width is 500 ps (scope
channels) or 2.5 ns (digital channels). Glitch range settings: <1.5 ns to <10 s (scope
channels), <5 ns to <10 s (digital channels).
Triggers on the line voltage powering the oscilloscope.
Triggers when a specified logical combination of the channels is entered, exited, is present
or absent for a specified period of time or is within a specified time range. Each channel
can have a value of high (H), low (L) or don’t care (X).
Pattern trigger clocked by the rising or falling edge, or both, of one channel.
Logic type: AND or NAND.
The trigger is qualified by an edge. After a specified time delay between 5 ns to 10 s, a
rising or falling edge on any one selected input will generate the trigger.
The trigger is qualified by an edge. After a specified delay between 1 to 16,000,000 rising or
falling edges on any one selected input will generate the trigger.
Trigger on one of the three standard television waveforms: 525 lines/60 Hz (NTSC)
625 lines/50 Hz (PAL), or define a custom waveform.
See trigger mode/glitch for performance characteristics. Greater than and less than
selections available.
Triggers on setup, hold or setup and hold violations in your circuit. Requires a clock and
data signal on any two input channels as trigger sources. High and low thresholds and
setup and/or hold time must then be specified.
Trigger on pulse rising or falling edges that do not cross two voltage levels in greater than
or less than the amount of time specified.
(continued)
23