LAN9211-ABZJ Standard Microsystems (SMSC), LAN9211-ABZJ Datasheet - Page 17

• Manufacturer Part Number: LAN9211-ABZJ
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9211-ABZJ

• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 56
• Lead Free Status / RoHS Status: Compliant

High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX Support
Datasheet
SMSC LAN9211
Auto-MDIX Enable
Crystal 1, Clock In
Wakeup Indicator
No Connect
Crystal 2
NAME
Reset
XTAL1/CLKIN
AMDIX_EN
SYMBOL
nRESET
XTAL2
PME
NC
Table 2.4 System and Power Signals
BUFFER
O8/OD8
OCLK
TYPE
lCLK
(PU)
(PU)
IS
I
DATASHEET
17
PINS
NUM
1
1
1
1
1
1
External 25MHz Crystal Input. This pin can also
No Connect. This pin must be left open.
be connected to single-ended TTL oscillator
(CLKIN). If this method is implemented, XTAL2
should be left unconnected.
External 25MHz Crystal output.
Active-low reset input. Resets all logic and
registers within the LAN9211. This signal is
pulled high with a weak internal pull-up resistor.
Note:
When programmed to do so, is asserted when
the LAN9211 detects a wake event and is
requesting the system to wake up from the
associated sleep state. The polarity and buffer
type of this signal is programmable.
Note:
Enables Auto-MDIX. Pull high or leave
unconnected to enable Auto-MDIX, pull low to
disable Auto-MDIX.
The LAN9211 must be reset on power-
up via nRESET or following power-up
via a soft reset (SRST). The LAN9211
must always be read at least once
after reset, or upon return from a
power-saving state or write operations
will not function. See
"Detailed Reset Description," on
page 46
Detection of a Power Management
Event, and assertion of the PME
signal will not wakeup the LAN9211.
The LAN9211will only wake up when it
detects a host write cycle (assertion of
nCS and nWR). Although any write to
the LAN9211, regardless of the data
written, will wake-up the device when
it is in a power-saving mode, it is
required that the BYTE_TEST register
be used for this purpose.
DESCRIPTION
for additional information
Section 3.11,
Revision 2.7 (03-15-10)