ISP1507CBS-T NXP Semiconductors, ISP1507CBS-T Datasheet - Page 52

• Manufacturer Part Number: ISP1507CBS-T
• Description: RF Transceiver USB 2.0 ULPI TRNSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1507CBS-T

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant
• Other names: ISP1507CBS,518

NXP Semiconductors
Table 41.
ISP1507C_ISP1507D_1
Product data sheet
Bit
7 to 4
3
2
1
0
Symbol
-
BVALID_FALL
BVALID_RISE
-
IGNORE_RESET
PWR_CTRL - Power Control register (address R = 3Dh to 3Fh, W = 3Dh, S = 3Eh, C = 3Fh) bit description
10.2 Extended register set
Addresses 00h to 3Fh of the extended register set directly map to the immediate set. This
means a read, write, set or clear operation to these extended addresses will operate on
the immediate register set.
Addresses 40h to FFh are not implemented. Operating on these addresses may result in
undefined behavior of the PHY.
Description
reserved; the link must never write logic 1 to these bits.
BVALID Fall: Enables RXCMDs for HIGH-to-LOW transitions on BVALID. When BVALID
changes from HIGH to LOW, the ISP1507 will send an RXCMD to the link with the ALT_INT
bit set to logic 1.
This bit is optional and is not necessary for OTG devices. This bit is provided for debugging
purposes. The session valid comparator must be used instead.
BVALID Rise: Enables RXCMDs for LOW-to-HIGH transitions on BVALID. When BVALID
changes from LOW to HIGH, the ISP1507 will send an RXCMD to the link with the ALT_INT
bit set to logic 1.
This bit is optional and is not necessary for OTG devices. This bit is provided for debugging
purposes. The session valid comparator must be used instead.
reserved
Ignore Reset: Selects between the RESET_N and PSW_N functions of the
RESET_N/PSW_N pin. The link must set this bit to logic 1, if PSW_N is used in a ganged
mode configuration.
0b — The RESET_N/PSW_N pin behaves as an active-LOW reset input (RESET_N). This is
the default setting.
1b — The RESET_N/PSW_N pin behaves as an active-LOW power switch output (PSW_N).
Rev. 01 — 28 May 2008
ULPI HS USB host and peripheral transceiver
ISP1507C; ISP1507D
© NXP B.V. 2008. All rights reserved.
51 of 74