S71PL129JB0BAW9Z0 Spansion Inc., S71PL129JB0BAW9Z0 Datasheet - Page 61

• Manufacturer Part Number: S71PL129JB0BAW9Z0
• Manufacturer: Spansion Inc.

Specifications of S71PL129JB0BAW9Z0

• Lead Free Status / RoHS Status: Compliant

A d v a n c e
I n f o r m a t i o n
During an Embedded Program or Erase algorithm operation, successive read cy-
cles to any address cause DQ6 to toggle. The system may use either OE# or CE#
to control the read cycles. When the operation is complete, DQ6 stops toggling.
After an erase command sequence is written, if all sectors selected for erasing
are protected, DQ6 toggles for approximately 400 µs, then returns to reading
array data. If not all selected sectors are protected, the Embedded Erase algo-
rithm erases the unprotected sectors, and ignores the selected sectors that are
protected.
The system can use DQ6 and DQ2 together to determine whether a sector is ac-
tively erasing or is erase-suspended. When the device is actively erasing (that is,
the Embedded Erase algorithm is in progress), DQ6 toggles. When the device en-
ters the Erase Suspend mode, DQ6 stops toggling. However, the system must
also use DQ2 to determine which sectors are erasing or erase-suspended. Alter-
natively, the system can use DQ7 (see
“DQ7: Data# Polling”
on page 56).
If a program address falls within a protected sector, DQ6 toggles for approxi-
mately 1 µs after the program command sequence is written, then returns to
reading array data.
DQ6 also toggles during the erase-suspend-program mode, and stops toggling
once the Embedded Program algorithm is complete.
Table 14
shows the outputs for Toggle Bit I on DQ6.
Figure 7
shows the toggle bit
algorithm.
Figure 19
in
“Read Operation Timings”
shows the toggle bit timing di-
agrams.
Figure 20
shows the differences between DQ2 and DQ6 in graphical
form. See also
“DQ2: Toggle Bit
II”.
October 28, 2005 S71PL129Jxx_00_A8
S71PL129JC0/S71PL129JB0/S71PL129JA0
59