750-841 WAGO, 750-841 Datasheet - Page 97

• Manufacturer Part Number: 750-841
• Description: CONTR.ETHERNET TCP/IP 10/100MBIT
• Manufacturer: WAGO

Specifications of 750-841

• Rohs Compliant: YES
• No. Of Digital Inputs: 10
• No. Of Digital Outputs: 10

3.1.8.4.2 Transmission by the Fieldbus
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
1. Start WAGO-I/O-PRO CAA by using the Windows Start menu, find and
2. In the Online program menu, click Communication parameters. The
3. In the Communication Parameters: New Channel dialog window, you
4. In the center window of the dialog, the following parameters appear:
5. Under the program menu item Online, click Log-on to log on to the
6. If the controller does not contain an application program, or it contains a
7. As soon as the program is loaded, you can start the controller by clicking on
8. To terminate the online operation, return to the Online menu and click on
When using the Ethernet Fieldbus port for communication with WAGO-I/O-
PRO CAA, the PC and the controller must be connected physically via
Ethernet (refer to Figure 5-2 and 5-3 for typical network connections).
Additionally, the TCP/IP communication driver in WAGO-I/O-PRO CAA
must be setup correctly and the controller must contain an IP address (refer to
section 3.1.6.4 for assigning an IP address to the controller).
A communication driver is required for Ethernet transmission. In
WAGO-I/O-PRO CAA, this driver and its parameters are entered in the
Communication Parameters dialog.
click on the WAGO-I/O-PRO program name (i.e., CoDeSys V2.3).
dialog window Communication parameters opens. Next, click New to
create a new communications channel and the Communication
Parameters: New Channel dialog window opens.
can enter a channel description in the “Name” field, then single click on
Tcp/Ip. Click the OK button to close the dialog window and the
Communication Parameters dialog window will regain focus.
Address=localHost, Port=2455, Motorola byteorder=No. Replace the
Address “localHost” with the IP address of your controller assigned via the
BootP server. If necessary, change the other entries accordingly. After all
data has been entered, Click OK. You can now test communication with
your controller.
controller. (During online operations the WAGO-I/O-PRO CAA server is
active and the Communication Parameters menu item cannot be accessed.)
different program, a dialog window appears asking whether or not the new
program should be loaded. Confirm with the Yes button.
the program menu item Online and then Run. At the right-hand side of the
status bar (the status bar is located at the bottom of the screen), the
RUNNING indicator will be highlighted.
the Log-off.
Note
To access the controller, it must have an IP address, and the operating
mode switch of the controller must be in the center or top position.
Fieldbus Controller 750-841
Fieldbus Controller
• 89