PEB20570FV31XP Lantiq, PEB20570FV31XP Datasheet - Page 186

• Manufacturer Part Number: PEB20570FV31XP
• Manufacturer: Lantiq

Specifications of PEB20570FV31XP

• Lead Free Status / Rohs Status: Compliant

MOSEL(1:0)
MODE(2:0)
MF_EN
OWIN(2:0)
Data Sheet
1 =
Interface Mode Selection (S/T, U
00 =
01 =
10 =
11 =
Mode Configuration (S/T, U
001 =
011 =
111 =
Multiframe Enable (S/T)
0 =
1 =
Oversampling Window Size (S/T, U
Specifies the width of the oversampling window in bit samples. The
window is centered about the middle of the bit. For example, a size of
16 means that, upon detection of (16/2) = 8 times logical ’1’, the
received bit is detected as ’1’. The window size is programmed in steps
of two as shown below:
000 =
001 =
010 =
DELIC read request of the TICCMR register which was sent to
the VIP. It includes initialization and configuration commands
and the channel addresses. The VIP returns these values
(instead of sending the actual VIP status information) within
the IOM-2000 STAT_n_m bit stream. The values are available
in the next frame (after next FSC) in DELIC TICSTR register.
Note: To avoid blocking, the DELIC must not issue this bit
Channel programmed to S/T mode
Channel programmed to U
reserved
reserved
Channel programmed to LT-T mode
Note: IOM-2000 cha. 0 and 1 are restricted to the modes LT-S
Channel programmed to LT-S mode (point-to-point or
extended passive bus configuration) or U
Channel programmed to LT-S mode (short passive bus mode)
Note: All other states are reserved. The reset value is 011, e.g.
Multiframes are disabled
Multiframes are enabled
2
4
6
during normal operation.
and U
programmed to the value 001 for these channels. Also
see
the default mode of VIP is LT-S
Section 3.2.4.2
PN
. This means that MODE(2..0) must not be
169
PN
)
PN
PN
)
on
PN
)
mode
page
58.
Register Description
PN
mode
PEB 20570
PEB 20571
2003-07-31