TS68EN360MAB/Q33L E2V, TS68EN360MAB/Q33L Datasheet - Page 11

• Manufacturer Part Number: TS68EN360MAB/Q33L
• Manufacturer: E2V

Specifications of TS68EN360MAB/Q33L

• Operating Temperature (max): 125C
• Operating Temperature Classification: Military
• Mounting: Surface Mount
• Lead Free Status / Rohs Status: Not Compliant

4. Detailed Specification
5. Applicable Documents
5.1
5.1.1
5.1.2
5.1.3
5.2
e2v semiconductors SAS 2008
Design and Construction
Absolute Maximum Ratings
Terminal Connections
Lead Material and Finish
Package
This specification describes the specific requirements for the microcontroller TS68EN360 - 25 MHz and
33 MHz in compliance with MIL-STD-883 class B or e2v standard screening.
The microcircuits are in accordance with the applicable document and as specified herein.
Depending on the package, the terminal connections shall be as shown in
Lead material and finish shall be as specified in MIL-STD-883 (see enclosed
page
The macrocircuits are packaged in hermetically sealed ceramic packages which are conform to case
outlines of MIL-STD-1835 or as follow:
The precise case outlines are described at the end of the specification
page
Table 5-1.
Notes:
Rating
Supply Voltage
Input Voltage
Storage Temperature Range
1. MIL-STD-883: test methods and procedures for electronics
2. MIL-PRF-38535: general specifications for microcircuits
3. DESC 5962-SMD-97607
• PGA but see
• CERQUAD
79)
77) and into MIL-STD-1835.
1. Permanent damage can occur if maximum ratings are exceeded. Exposure to voltages or currents in
2. Although sections of the device contain circuitry to protect against damage from high static voltages or
3. The supply voltage V
excess of recommended values affects device reliability. Device modules may not operate normally
while being exposed to electrical extremes.
electrical fields, take normal precautions to avoid exposure to voltages higher than maximum-rated
voltages.
properly.Unless otherwise stated, all voltages are referenced to the reference terminal.
(1)(2)
Absolute Maximum Ratings
(1)(2)
“241-pin – PGA” on page 77
CC
must start and restart from 0.0V; otherwise, the 360 will not come out of reset
Symbol
T
V
V
STG
CC
IN
-0.3 to +6.5
-0.3 to +6.5
-55 to +150
Value
(“Package Mechanical Data” on
Figure 2-1
“Ordering Information” on
0886C–HIREL–04/08
TS68EN360
and
Figure
Unit
V
V
C
2-2.
11