MPCBL5524A1D Intel, MPCBL5524A1D Datasheet - Page 35

• Manufacturer Part Number: MPCBL5524A1D
• Manufacturer: Intel

Specifications of MPCBL5524A1D

• Lead Free Status / Rohs Status: Supplier Unconfirmed

3.9
Intel NetStructure
Note: If the installation requires a non-bootable CD-ROM, it is necessary to boot an OS with the proper
Installing the Operating System
For more detailed information about your operating system, refer to the documentation provided by
the operating system vendor and to the ZT 5524 / MPCBL5524 Product Page on the Intel website
(URL listed in
To install the operating system
CD-ROM drivers in order to access the CD-ROM drive.
1. Install peripheral devices. CompactPCI devices are automatically configured by the BIOS
2. Install, configure and test any devices that will be used in the installation process. Most
3. Read the release notes and installation documentation provided by the operating system
4. Select the appropriate boot device order in the Setup boot menu depending on the OS
5. Proceed with the OS installation as directed, being sure to select appropriate device types if
6. When installation is complete, reboot the system and set the boot device order in the Setup
7. The Flash Write Protect/Write Enable switch, SW4-1, must be open when installing an
®
during the boot sequence.
operating systems require initial installation on a hard drive from a floppy or CD-ROM drive.
vendor. Be sure to read any readme files or documents provided with the OS as these typically
note documentation discrepancies or compatibility problems.
installation media used. For example, if the OS includes a bootable installation floppy, select
Removable Media as the first boot device and reboot the system with the installation floppy
installed in the floppy drive.
prompted. For specific device types and compatibility modes of Intel NetStructure product,
refer to the appropriate hardware documentation (see
boot menu.
operating system image into flash. See
Enable)”
ZT 5524 / MPCBL5524 High-Performance System Master Processor Board TPS
— In order to boot from a USB CD-ROM you must first connect the USB drive, then enter
— To boot from a USB Floppy you must connect the floppy device to the board, then enter
the BIOS Setup utility and move the “CD-ROM” device to the top of the boot list (or
above any other bootable devices).
the BIOS Setup utility, move “Removable Devices” to the top of the boot order on the
Boot screen and then move the USB floppy device to the top of the removable devices list.
for more information.
Appendix E, “ZT 5524 / MPCBL5524 Product Page”
Chapter 4, “SW4-1 (Flash Write Protect/Write
Appendix E, “User
on
page
89).
Documentation.”).
Getting Started
35