DLP-HS-FPGA DLP Design Inc, DLP-HS-FPGA Datasheet - Page 5

• Manufacturer Part Number: DLP-HS-FPGA
• Description: MODULE USB-TO-FPGA SPARTAN3
• Manufacturer: DLP Design Inc

Specifications of DLP-HS-FPGA

• Module/board Type: FPGA Module
• Interface Type: USB, SPI
• Data Bus Width: 32 bit
• Operating Supply Voltage: 5 V
• Product: Interface Modules
• For Use With/related Products: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 813-1030

3.0 ABSOLUTE MAXIMUM RATINGS
Stresses above those listed here may cause permanent damage to the DLP-HS-FPGA:
Operating Temperature: 0-70°C
Voltage on Digital Inputs with Respect to Ground: -0.5V to +4.1 V
Sink/Source Current on Any I/O: 24 mA (using LVTTL as the FPGA I/O Standard)
4.0 WARNINGS
5.0 BITLOADAPP SOFTWARE
Windows software is provided for use with the DLP-HS-FPGA that will load an FPGA configuration
(.bit) file directly to the SPI Flash device via the USB interface. This application (shown below) will
allow the user to erase the flash, verify the erasure and then program and verify the flash:
6.0 JTAG INTERFACE
The easiest way to load an FPGA configuration (.bit) file to the FPGA is to run the BitLoadApp
software, then select and program a file from the local hard drive directly to the SPI flash. Once
written to the SPI flash, the configuration will load to the FPGA and execute. Alternatively, a
traditional JTAG header location is provided on the DLP-HS-FPGA giving the user access to the pins
on the FPGA required by the development tools. (Refer to the schematic at the end of this datasheet
for details.)
Rev. 1.1 (December 2009)
•
•
•
Unplug from the host PC and power adapter before connecting to I/O on the DLP-HS-FPGA.
Isolate the bottom of the board from all conductive surfaces.
Observe static precautions to prevent damage to the DLP-HS-FPGA module.
5
© DLP Design, Inc.