ES1-LW100H Omron, ES1-LW100H Datasheet - Page 42

• Manufacturer Part Number: ES1-LW100H
• Description: Sensor Hardware & Accessories Infrared Sensor
• Manufacturer: Omron

Specifications of ES1-LW100H

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

42
E5EZ-PRR
Wiring Terminals
E5EZ-PRR
Nomenclature
E5EZ-PRR
Standard insulation is applied to the temperature gauge's I/O sections. If reinforced insulation is required, connect the input and output terminals
to a device without any exposed current-carrying parts, or to a device with standard insulation suitable for the maximum operation voltage of
the power supply I/O section.
For E5EZ-PRR@03-model products, in order to satisfy the conduction and emission specifications of EN61326CLASSA, a magnetic ring (TDK:
ZAT1730-0730) should be added to the communications line between the K3SC unit and the controller.
100 to 240 VAC
1. ALM1 (alarm 1)
2. OUT1, OUT2 (control output 1, control output 2)
3. STOP (Stop)
4. CMW (Communications Writing Control)
5. MANU (Manual Mode)
is ON.
operation is stopped by an event or by using the
RUN/STOP function.
and is not lit when it is disabled.
manual mode.
Lights when alarm 1 output is ON.
ALM2 (alarm 2)
Lights when alarm 2 output is ON.
Lights when control output 1 or control output 2
Lights when operation is stopped.
During operation, this indicator lights when
Lights when communications writing is enabled
Lights when the auto/manual mode is set to
Potentiometer
Press this key to move between setting
levels. The setting level is selected in
the following order: operation level:
adjustment level, initial setting level,
communications setting level.
Press this key to change parameters
within a setting level.
Operation Indicators
Analog Input
mA
Control Output 1 (OPEN Output)
Control Output 2 (CLOSE Output)
DO NOT
USE
50/60 Hz
V
Mode Key
Level Key
DO NOT
USE
CLOSE
WIPE
OPEN
TC
DO NOT
USE
Pt
Temperature Unit
The temperature unit is displayed when parameters are set to display a temperature.
The display is determined by the currently selected "temperature unit" parameter set value.
c indicates C and f indicates F.
A
B
B
10
11
1
2
3
4
5
6
7
8
9
Each press of this key decrements values displayed on the No. 2 display or
reverses the setting. Holding the key down speeds up the decrementation.
Down Key
MANU
A
12
13
14
20
21
22
M
Alarm Output 1
Event Input
EV2
PV
SV
MV
EV1
Alarm Output 2
No. 1 Display
No. 2 Display
No. 3 Display
Displays valve open percentage when valve opening
display is on.
Nothing will be displayed when valve opening display
is switched off.
Up Key
Automatic/ Manual Key
Displays the process value or parameter type.
Lights for approximately one second during startup.
Press this key for at least one second to switch
between automatic and manual mode.
Displays the set point, parameter operation read
value, or the variable input value.
Lights for approximately one second during startup.
Each press of this key increments the value displayed
on the No. 2 display or advances the setting. Holding
the key down speeds up the incrementation.
Communications
12
13
14
RS232C
SD
RD
SG
12
13
14
Communications
RS485
B(+)
DO NOT
USE