MMA8205EG Freescale Semiconductor, MMA8205EG Datasheet - Page 13

• Manufacturer Part Number: MMA8205EG
• Description: Board Mount Accelerometers X- AXIS 50G SOIC 16
• Manufacturer: Freescale Semiconductor
• Series: MMA82r

Specifications of MMA8205EG

• Sensing Axis: X
• Acceleration: 50 g
• Sensitivity: 8.02 mV/g
• Package / Case: SOIC-16
• Axis: X or Y
• Acceleration Range: ±50g
• Voltage - Supply: 6.3 V ~ 30 V
• Output Type: Digital
• Bandwidth: -
• Interface: SPI
• Mounting Type: Surface Mount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Sensors
Freescale Semiconductor
3.2.6.4
This bit may be programmed at any time, regardless of the state of LOCK2. This bit is intended to be programmed when a module
has been determined by the DSI Bus Master to be defective. Programming this bit after LOCK2 has been set will cause the device
to respond to short word Read Acceleration Data commands with a zero response. Acceleration results are not affected by this
bit when long word Read Acceleration Data commands are executed, however the Status (S) bit will be set in the response.
1 - Device responds to Read Acceleration Data command with zero value
0 - Device responds normally to Read Acceleration Data command
3.2.6.5
These bits define the pre-programmed DSI Bus device address.
3.3
Two different methods of programming the eighty customer defined bits are supported. In test mode, these may be programmed
in the same manner as factory programmed OTP bits. Additionally, the Read Write NVM DSI bus command may be used. Test
mode programming operations are described in
Section
4.6.3.
OTP PROGRAMMING
Device Disable Bit (DDIS)
Device Address (AD3 - AD0)
Appendix
A.3. Read Write NVM command operation is described in
MMA81XXEG
13