RP-LS42F-75LE BANNER ENGINEERING, RP-LS42F-75LE Datasheet - Page 6

• Manufacturer Part Number: RP-LS42F-75LE
• Description: SAFETY SWITCH; ROPE PULL; LATCH; 2 NC; MAX 75M; E-STOP BUTTON
• Manufacturer: BANNER ENGINEERING
• Type: Safetyr

Specifications of RP-LS42F-75LE

• Actuator Type: Latch
• Body Style: Rectangular
• Current, Rating: 50 mA
• Ip Rating: IP67
• Number Of Positions: 2
• Voltage, Rating: 10-30 VDC

Rope Pull Emergency Stop Switches –
Access to Wiring Chamber
The wiring chamber is accessed via the hinged door. Simply insert a flat-blade
screwdriver, as shown in Figure 5, and pry gently down to open. Select the best wiring
entrance and thread in the ½" x 14 NPSM conduit adapter (supplied), or the optional
M20 x 1.5 cable gland (page 11). The switch knockout will break loose with the final turn
of the conduit adapter or cable gland.
Figure 5. Access to wiring chamber – use a small flat-blade screwdriver
Wiring
These switch models have redundant pairs of safety contacts, so they may be wired for
either single-channel or dual-channel output to a safety module or E-stop circuit. Monitor
contacts, in either case, may be wired as desired to an external alarm device.
Single-Channel Output: Wire contacts 21/22 or 41/42 together to the input of a safety
module or E-stop circuit.
Dual-Channel Output: Wire contacts 21/22 and 41/42 independently to the two safety
module inputs (see Figure 6).

To open wiring chamber:
1. Insert the screwdriver blade
P/N 67709 rev. A
into slot in cover to pry cover
open.
Electrical Installation
To connect wires to terminals:
1. Insert the screwdriver blade into the slot below the
2. Twist the screwdriver blade in the slot to open the
3. Hold wire in place and remove screwdriver.
desired wiring terminal.
terminal jaws; insert wire.
RP-LS42F-75L.. Series
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
Figure . Wire the two switch contacts in
CH 2
Dual-Channel Safety Device
series
CH 1