MT48H8M16LFB4-75 IT:KTR Micron Technology Inc, MT48H8M16LFB4-75 IT:KTR Datasheet - Page 18

• Manufacturer Part Number: MT48H8M16LFB4-75 IT:KTR
• Manufacturer: Micron Technology Inc

Specifications of MT48H8M16LFB4-75 IT:KTR

• Lead Free Status / Rohs Status: Compliant

Table 9: I
Notes 1, 5, 9, and 10 apply to all parameters and conditions; V
PDF: 09005aef832ff1ea
128mb_mobile_sdram_y35M.pdf - Rev. G 10/09 EN
Parameter/Condition
Self refresh:
CKE = LOW;
Address and control inputs are sta-
ble; Data bus inputs are stable
DD7
t
CK =
Specifications and Conditions (x16 and x32)
t
CK (MIN);
Notes:
10. Values for I
1. A full initialization sequence is required before proper device operation is ensured.
2. I
3. The I
4. Address transitions average one transition every 2 clocks.
5. Measurement is taken 500ms after entering into this operating mode to provide tester
6. Other input signals can transition only one time for every 2 clocks and are otherwise at
7. CKE is HIGH during the REFRESH command period
8. Typical values at 25˚C (not a maximum value).
9. Enables on-die refresh and address counters.
minimum cycle time and the outputs open.
quency alteration for the test condition.
measuring unit settling time.
valid V
limit is a nominal value and does not result in a fail value.
ture range. All other I
DD
is dependent on output loading and cycle rates. Specified values are obtained with
DD
IH
current will increase or decrease proportionally according to the amount of fre-
or V
1/16 array, 85˚C
1/16 array, 45˚C
Full array, 85˚C
Full array, 45˚C
1/2 array, 85˚C
1/2 array, 45˚C
1/4 array, 85˚C
1/4 array, 45˚C
1/8 array, 85˚C
1/8 array, 45˚C
DD7
IL
levels.
85˚C full array and partial array are guaranteed for the entire tempera-
128Mb: 8 Meg x 16, 4 Meg x 32 Mobile SDRAM
DD7
values are estimated.
18
DD
Electrical Specifications – I
/V
DDQ
= 1.70–1.95V
Micron Technology, Inc. reserves the right to change products or specifications without notice.
Symbol
I
DD7
t
RFC (MIN) else CKE is LOW. The I
I
200
140
160
120
140
100
120
100
DD7
95
90
©2008 Micron Technology, Inc. All rights reserved.
DD
Parameters
Unit
μA
μA
μA
μA
μA
μA
μA
μA
μA
μA
DD7