AT32UC3A464 Atmel Corporation, AT32UC3A464 Datasheet - Page 419

• Manufacturer Part Number: AT32UC3A464
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A464

• Flash (kbytes): 64 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

• WDRBT: Wait Data Read Before Transfer
• MODFDIS: Mode Fault Detection
• PCSDEC: Chip Select Decode
• PS: Peripheral Select
• MSTR: Master/Slave Mode
32072G–11/2011
0: The FIFO is not used in reception (only one character can be stored in the SPI).
1: In master mode, a transfer can start only if the RDR register is empty, i.e. does not contain any unread data. This mode
prevents overrun error in reception.
0: No Effect. In master mode, a transfer can be initiated whatever the state of the RDR register is.
1: Mode fault detection is disabled. If the I/O controller does not have open-drain capability, mode fault detection must be
disabled for proper operation of the SPI.
0: Mode fault detection is enabled.
0: The chip selects are directly connected to a peripheral device.
1: The four chip select lines are connected to a 4- to 16-bit decoder.
When PCSDEC equals one, up to 15 Chip Select signals can be generated with the four lines using an external 4- to 16-bit
decoder. The CSRn registers define the characteristics of the 15 chip selects according to the following rules:
CSR0 defines peripheral chip select signals 0 to 3.
CSR1 defines peripheral chip select signals 4 to 7.
CSR2 defines peripheral chip select signals 8 to 11.
CSR3 defines peripheral chip select signals 12 to 14.
1: Variable Peripheral Select.
0: Fixed Peripheral Select.
1: SPI is in master mode.
0: SPI is in slave mode.
419