SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 30

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Programmer’s Model
2.1
2-2
About the programmer’s model
The system control coprocessor (CP15) is used to configure and control the
ARM926EJ-S processor. The caches, Tightly-Coupled Memories (TCMs), Memory
Management Unit (MMU), and most other system options are controlled using CP15
registers. You can only access CP15 registers with MRC and MCR instructions in a
privileged mode. CDP, LDC, STC, MCRR, and MRRC instructions, and unprivileged
MRC or MCR instructions to CP15 cause the Undefined instruction exception to be
taken.
Copyright © 2001-2003 ARM Limited. All rights reserved.
ARM DDI0198D