SAM9G46 Atmel Corporation, SAM9G46 Datasheet - Page 26

• Manufacturer Part Number: SAM9G46
• Manufacturer: Atmel Corporation

Specifications of SAM9G46

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: AES/DES
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

7.2.4.1
7.2.4.2
26
SAM9G46
BMS = 1, boot on embedded ROM
BMS = 0, boot on external memory
The system boots on Boot Program.
For optimization purpose, nothing else is done. To speed up the boot sequence user pro-
grammed software should perform a complete configuration:
• Boot on on-chip RC
• Enable the 32768 Hz oscillator
• Auto baudrate detection
• Downloads and runs an application from external storage media into internal SRAM
• Downloaded code size depends on embedded SRAM size
• Automatic detection of valid application
• Bootloader on a non-volatile memory
• SAM-BA Boot in case no valid program is detected in external NVM, supporting
• Boot on on-chip RC
• Boot with the default configuration for the Static Memory Controller, byte select mode, 16-bit
• Enable the 32768 Hz oscillator if best accuracy needed
• Program the PMC (main oscillator enable or bypass mode)
• Program and Start the PLL
• Reprogram the SMC setup, cycle, hold, mode timings registers for EBI CS0 to adapt them to
• Switch the main clock to the new value
data bus, Read/Write controlled by Chip Select, allows boot on 16-bit non-volatile memory.
the new clock
– SPI DataFlash/SerialFlash connected on NPCS0 of the SPI0
– SDCard
– NandFlash
– EEPROM connected on TWI0
– Serial communication on a DBGU
– USB Device HS Port
11028CS–ATARM–20-Apr-11