SAM9G46 Atmel Corporation, SAM9G46 Datasheet - Page 35

• Manufacturer Part Number: SAM9G46
• Manufacturer: Atmel Corporation

Specifications of SAM9G46

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: AES/DES
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

8.7
11028CS–ATARM–20-Apr-11
Power Management Controller
The Power Management Controller provides all the clock signals to the system.
PMC input clocks:
PMC output clocks
Note:
This allows the software control of five flexible operating modes:
• Switch from 32768 Hz oscillator to internal RC oscillator by setting the bit OSCSEL to 0.
• Wait 5 slow clock cycles for internal resynchronization.
• Disable the 32768Hz oscillator by setting the bit OSC32EN to 0.
• UPLLCK: From UTMI PLL
• PLLACK From PLLA
• SLCK: slow clock from OSC32K or internal RC OSC
• MAINCK: from 12 MHz external oscillator
• Processor Clock PCK
• Master Clock MCK, in particular to the Matrix and the memory interfaces. The divider can be
• DDR system clock equal to 2xMCK
• USB Host EHCI High speed clock (UPLLCK)
• USB OHCI clocks (UHP48M and UHP12M)
• Independent peripheral clocks, typically at the frequency of MCK
• Two programmable clock outputs: PCK0 and PCK1
• Normal Mode, processor and peripherals running at a programmable frequency
• Idle Mode, processor stopped waiting for an interrupt
• Slow Clock Mode, processor and peripherals running at low frequency
• Standby Mode, mix of Idle and Backup Mode, peripheral running at low frequency, processor
• Backup Mode, Main Power Supplies off, VDDBU powered by a battery
1,2,3 or 4
stopped waiting for an interrupt
DDR system clock is not available when Master Clock (MCK) equals Processor Clock (PCK).
SAM9G46
35