SAM9G46 Atmel Corporation, SAM9G46 Datasheet - Page 38

• Manufacturer Part Number: SAM9G46
• Manufacturer: Atmel Corporation

Specifications of SAM9G46

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: AES/DES
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

8.14
8.15
38
Debug Unit
Chip Identification
SAM9G46
The SAM9G46 Chip ID is defined in the Debug Unit Chip ID Register and Debug Unit Chip ID
Extension Register.
• One External Sources plus the Fast Interrupt signal
• 8-level Priority Controller
• Vectoring
• Protect Mode
• Fast Forcing
• Composed of two functions
• Two-pin UART
• Debug Communication Channel Support
• Chip ID: 0x819B05A2
• Ext ID: 0x00000003
• JTAG ID: 05B2_703F
• ARM926 TAP ID: 0x0792603F
– Drives the Normal Interrupt of the processor
– Handles priority of the interrupt sources 1 to 31
– Higher priority interrupts can be served during service of lower priority interrupt
– Optimizes Interrupt Service Routine Branch and Execution
– One 32-bit Vector Register per interrupt source
– Interrupt Vector Register reads the corresponding current Interrupt Vector
– Easy debugging by preventing automatic operations when protect modes are
– Permits redirecting any normal interrupt source on the Fast Interrupt of the
– Two-pin UART
– Debug Communication Channel (DCC) support
– Implemented features are 100% compatible with the standard Atmel USART
– Independent receiver and transmitter with a common programmable Baud Rate
– Even, Odd, Mark or Space Parity Generation
– Parity, Framing and Overrun Error Detection
– Automatic Echo, Local Loopback and Remote Loopback Channel Modes
– Support for two PDC channels with connection to receiver and transmitter
– Offers visibility of and interrupt trigger from COMMRX and COMMTX signals from
enabled
processor
Generator
the ARM Processor’s ICE Interface
11028CS–ATARM–20-Apr-11