SAM9M10 Atmel Corporation, SAM9M10 Datasheet - Page 1200

• Manufacturer Part Number: SAM9M10
• Manufacturer: Atmel Corporation

Specifications of SAM9M10

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: Yes
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

1: clock is gated for decoder structures that are not used.
Clock gating value should be changed only when the decoder is disabled.
• LAT_COMP: Decoder Latency Compensation
Decoder latency compensation value in clock cycles.
If the best case latency (from bus request to bus grant, or from data request to data receive) is known, the value can be
written to these register bits used to compensate the delay. If the latency value is unknown, these bits should be written to
zero.
Note:
Setting the compensation value higher than the best case latency can cause data corruption.
• DOPF: Decoder Output Picture Format
0: Output format is raster scan, i.e. pixel rows are written in consecutive memory.
1: Output format is tiled, i.e. macroblocks are written in consecutive memory addresses.
• AHB_BURST: AHB Precise Burst and Data Discard Enable
0: INCR bursts of undefined length 2 or 3 may be issued when necessary.
1: Only the precise AHB bursts (SINGLE, INCR4, INCR8 and INCR16) are used in SDRAM read accesses. Extra data is
discarded internally.
• DI_LE: Decoder Input Endian Mode
0: Big endian
1: Little endian
• HTI: Hardware Timeout Interrupt Enable
0: Hardware timeout interrupt disable.
1: Hardware timeout interrupt enable.
SAM9M10
1200
6355D–ATARM–7-Sep-11