73S1217F Maxim, 73S1217F Datasheet - Page 17

• Manufacturer Part Number: 73S1217F
• Description: The Teridian 73S1217F is a self-contained SoC smart card reader IC that is an ideal solution for any USB-connected ISO 7816 design
• Manufacturer: Maxim

Register
FLSHCTL
TRIMPCtl
FUSECtl
SECReg
Rev. 1.2
Address
0xFFD1
0xFFD2
0xFFD7
0xB2
SFR
R/W
R/W
R/W
R/W
R/W
W
W
W
W
R
Bit 0 (FLSH_PWE): Program Write Enable:
0 – MOVX commands refer to XRAM Space, normal operation (default).
1 – MOVX @DPTR,A moves A to Program Space (Flash) @ DPTR.
This bit is automatically reset after each byte written to flash. Writes to this
bit are inhibited when interrupts are enabled.
Bit 1 (FLSH_MEEN): Mass Erase Enable:
0 – Mass Erase disabled (default).
1 – Mass Erase enabled.
Must be re-written for each new Mass Erase cycle.
Bit 6 (SECURE):
Enables security provisions that prevent external reading of flash memory
and CE program RAM. This bit is reset on chip reset and may only be set.
Attempts to write zero are ignored.
0xA6 value will cause the selected fuse to be blown. All other values will
stop the burning process.
0x54 value will set up for security fuse control. All other values are
reserved and should not be used.
Bit 7 (PARAMSEC):
0 – Normal operation.
1 – Enable permanent programming of the security fuses.
Bit 5 (SECPIN):
Indicates the state of the SEC pin. The SEC pin is held low by a pull-down
resistor. The user can force this pin high during boot sequence time to
indicate to firmware that sec mode 1 is desired.
Bit 1 (SECSET1):
See the Program Security section.
Bit 0 (SECSET0):
See the Program Security section.
Table 5: Program Security Registers
Description
17