STVM100DS6F STMicroelectronics, STVM100DS6F Datasheet - Page 7

IC I2C LCD VCOM CALIBRATR 8TSSOP

STVM100DS6F

Manufacturer Part Number
STVM100DS6F
Description
IC I2C LCD VCOM CALIBRATR 8TSSOP
Manufacturer
STMicroelectronics
Type
Calibratorr
Datasheet

Specifications of STVM100DS6F

Applications
TFT-LCD Panels: VCOM Driver
Mounting Type
Surface Mount
Package / Case
8-TSSOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
497-9082-2
STVM100DS6F

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
STVM100DS6F
Manufacturer:
ST
0
Part Number:
STVM100DS6F
Manufacturer:
ST
Quantity:
20 000
STVM100
2
2.1
2.1.1
2.1.2
2.1.3
Device operation
The STVM100 operates as a slave device on the serial bus. Access is obtained by
implementing a start condition, followed by the 7-bit slave address (1001111), and the
eighth bit for READ/WRITE identification. The volatile DAC register and non-volatile
EEPROM values can be read out or written in.
2-wire bus characteristics and conditions
This bus is intended for communication between different ICs. It consists of two lines:
The SDA and SCL lines must be connected to a positive supply voltage via a pull-up
resistor. The following protocols have been defined:
Bus not busy
Both data and clock lines remain high.
Start data transfer
A change in the data line state from high-to-low while the clock is high indicate the start
condition.
Stop data transfer
A change in the data line state from low-to-high while the clock is high indicates the stop
condition.
a bi-directional data signal (SDA).
a clock signal (SCL).
Data transfer may be initiated only when the bus is not busy.
During data transfer, the data line must remain stable whenever the clock line is high.
Changes in the data line while the clock line is high will be interpreted as control
signals.
Doc ID 13236 Rev 7
Device operation
7/27

Related parts for STVM100DS6F