STVM100DS6F STMicroelectronics, STVM100DS6F Datasheet - Page 8

• Manufacturer Part Number: STVM100DS6F
• Description: IC I2C LCD VCOM CALIBRATR 8TSSOP
• Manufacturer: STMicroelectronics
• Type: Calibratorr

Specifications of STVM100DS6F

• Applications: TFT-LCD Panels: VCOM Driver
• Mounting Type: Surface Mount
• Package / Case: 8-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-9082-2; STVM100DS6F

Device operation
2.1.4
8/27
Data valid
The data on the SDA line must be stable during the high period of the clock. The high or low
state of the data line can only change when the clock signal on the SCL line is low (see
Figure
one clock pulse per bit of data.
Each data transfer is initiated with a start condition and terminated with a stop condition.
The number of data bytes transferred between the start and stop conditions is not limited.
The information is transmitted byte-wide and each receiver acknowledges transmission with
a ninth bit.
By definition, the device that gives out a message is called “transmitter”, the device that gets
the message is called “receiver”. The device that controls the message is called the
“master”. The devices controlled by the master are called “slave” devices.
Figure 5.
CLOCK
DATA
5). The data on the line may be changed during the clock signal low period. There is
CONDITION
Serial bus data transfer sequence
START
Doc ID 13236 Rev 7
DATA VALID
DATA LINE
STABLE
DATA ALLOWED
CHANGE OF
CONDITION
STOP
STVM100
AI00587