PIC16C765 Microchip Technology Inc., PIC16C765 Datasheet - Page 64

• Manufacturer Part Number: PIC16C765
• Description: 8-bit Cmos Microcontrollers With Usb
• Manufacturer: Microchip Technology Inc.

PIC16C745/765
10.5.1.5
The USB Status Register reports the transaction sta-
tus within the USB. When the MCU recognizes a
TOK_DNE interrupt, this register should be read to
determine the status of the previous endpoint commu-
nication. The data in the status register is valid when
the TOK_DNE interrupt bit is asserted.
The USTAT register is actually a read window into a
status FIFO maintained by the USB. When the USB
uses a BD, it updates the status register. If another
REGISTER 10-5: USB STATUS REGISTER (USTAT: 194h)
DS41124C-page 64
bit7
bit 7-5: Unimplemented: Read as ’0’
bit 4-3: ENDP<1:0>: These bits encode the endpoint address that received or transmitted the previous token.
bit 2:
bit 1-0: Unimplemented: Read as ’0’
U-0
—
Status Register (USTAT)
This allows the microprocessor to determine which BDT entry was updated by the last USB transaction.
IN: This bit indicates the direction of the last BD that was updated
1 = The last transaction was an IN TOKEN
0 = The last transaction was an OUT or SETUP TOKEN
U-0
—
U-0
—
ENDP1
R-X
ENDP0
Preliminary
R-X
R-X
IN
USB transaction is performed before the TOK_DNE
interrupt is serviced the USB will store the status of the
next transaction in the STAT FIFO. Thus, the STAT
register is actually a four byte FIFO which allows the
MCU to process one transaction while the SIE is pro-
cessing the next. Clearing the TOK_DNE bit in the
INT_STAT register causes the SIE to update the STAT
register with the contents of the next STAT value. If the
data in the STAT holding register is valid, the SIE will
immediately reassert the TOK_DNE interrupt.
U-0
—
U-0
—
bit0
2000 Microchip Technology Inc.
R = Readable bit
W = Writable bit
U = Unimplemented bit,
-n = Value at POR reset
X = Don’t care
read as ‘0’