SCA05010-BFN-LNN Shelly, Inc., SCA05010-BFN-LNN Datasheet - Page 25

• Manufacturer Part Number: SCA05010-BFN-LNN
• Description: Innovative Display Technologies 17171 Murphy Avenue
• Manufacturer: Shelly, Inc.

Precautions for Operation
show the best contrast.
voltage then the limit cause the shorter LCD life. An electrochemical reaction due to direct current causes
LCD's undesirable deterioration, so that the use of direct current drive should be avoided.
range and on the other hand at higher temperature LCD's show dark color in them. However those
phenomena do not mean malfunction or out of order with LCD's, Which will come back in the specified
operating temperature.
it will return to normal if it is turned off and then back on.
terminal open circuit. Usage under the maximum operating temperature,50%RH or less is required.
bubble generation or polarizer peel-off may occur with high temperature and high humidity.
Safety
solvents such as acetone and ethanol, which should later be burned.
thoroughly with soap and water.
Limited Warranty
repair any of its LCD modules which are found to be functionally defective when inspected in accordance
with Shelly Associates Inc. acceptance standards (copies available upon request) for a period of one year
from date of shipments. Cosmetic/visual defects must be returned to Shelly Associates Inc. within 90 days
of shipment. Confirmation of such date shall be based on freight documents. The warranty liability of
Shelly Associates Inc. is limited to repair and/or replacement on the terms set forth above. Shelly
Associates Inc. will not be responsible for any subsequent or consequential events.
(7) Please keep the temperature within specified range for use and storage. Polarization degradation,
(1) Viewing angle varies with the change of liquid crystal driving voltage (VLCD). Adjust VLCD to
(2) It is an indispensable condition to drive LCD's within the specified voltage limit since the higher
(3) Response time will be extremely delayed at lower temperature than the operating temperature
(4) If the display area is pushed hard during operation, the display will become abnormal. However,
(5) A slight dew depositing on terminals is a cause for electro-chemical reaction resulting in
(6) Input each signal after the positive/negative voltage becomes stable.
(1) It is recommended to crush damaged or unnecessary LCDs into pieces and wash them off with
(2) If any liquid leaks out of a damaged glass cell and comes in contact with the hands, wash off
Unless agreed between Shelly Associates Inc. and customer, Shelly Associates Inc. will replace or
25 |
P a g e