MT90401 Zarlink Semiconductor, MT90401 Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/7/727/zarlink_semiconductor_sml.jpg)
MT90401
Manufacturer Part Number
MT90401
Description
Sonet/sdh System Synchronizer
Manufacturer
Zarlink Semiconductor
Datasheet
1.MT90401.pdf
(38 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MT90401AB
Manufacturer:
ZARLINK
Quantity:
500
Company:
Part Number:
MT90401AB1
Manufacturer:
st
Quantity:
421
1.0
The MT90401 is a SONET/SDH System Synchronizer, providing timing (clock) and synchronization (frame) signals
to interface circuits for Digital Telecommunications Transmission links. Figure 1 is a functional block diagram which
is described in the following sections.
1.1
The MT90401 accepts two simultaneous reference input signals and operates on their falling edges. Either the
primary reference (PRI) signal or the secondary reference (SEC) signal can be selected as input to the TIE
Corrector Circuit. The selection is based on the Control, Mode and Reference Selection of the device. See Table 1
and Table 4.
1.2
The MT90401 operates with one of four possible input reference frequencies (8kHz, 1.544MHz, 2.048MHz or
19.44MHz). The frequency select inputs, FS1 and FS2, which come from pins in hardware mode and control bits in
microport mode determine which of the four frequencies may be used at the reference inputs (PRI and SEC). Both
inputs must have the same frequency applied to them. A reset (RST) must be performed after every frequency
select input change. See Table 1 - Input Frequency Selection.
1.3
The TIE corrector circuit, when enabled, prevents a step change in phase on the input reference signals (PRI or
SEC) from causing a step change in phase at the input of the DPLL block of Figure 1.
During reference input rearrangement, such as during a switch from the primary reference (PRI) to the secondary
reference (SEC), a step change in phase on the input signals will occur. A phase step at the input of the DPLL
would lead to unacceptable phase changes in the output signal.
As shown in Figure 3, the TIE Corrector Circuit receives one of the two reference (PRI or SEC) signals, passes the
signal through a programmable delay line, and uses this delayed signal as an internal virtual reference, which is
input to the DPLL. Therefore, the virtual reference is a delayed version of the selected reference. During a switch
from one reference to the other, the State Machine first changes the mode of the device from Normal to Holdover. In
Holdover Mode, the DPLL no longer uses the virtual reference signal, but generates an accurate clock signal using
storage techniques. The Compare Circuit then measures the phase delay between the current phase (feedback
signal) and the phase of the new reference signal. This delay value is passed to the Programmable Delay Circuit
(See Figure 3). The new virtual reference signal is now at the same phase position as the previous reference signal
would have been if the reference switch had not taken place. The State Machine then returns the device to Normal
Mode.
Reference Select MUX Circuit
Frequency Select MUX Circuit
Time Interval Error (TIE) Corrector Circuit
Functional Description
FS2
0
0
1
1
Table 1 - Frequency Selection
FS1
0
1
0
1
Zarlink Semiconductor Inc.
MT90401
19.44MHz
See FS2 and FS1 bit description
inTable 6 - Control Register 1
(Address 00H - Read/Write)
8kHz
1.544MHz
2.048MHz
10
Input Frequency
Data Sheet