NL10276BC20_07Y NEC, NL10276BC20_07Y Datasheet - Page 20

• Manufacturer Part Number: NL10276BC20_07Y
• Description: Display Module
• Manufacturer: NEC

www.DataSheet.co.kr
5. PRECAUTIONS
5.1 MEANING OF CAUTION SIGNS
5.2 CAUTIONS
5.3 ATTENTIONS
5.3.1 Handling of the product
understanding this contents!
The following caution signs have very important meaning. Be sure to read "5.2 CAUTIONS", after
The product must be installed using mounting holes without undue stress such as bends or twist (See
outline drawings). And do not add undue stress to any portion (such as bezel flat area) except
mounting hole portion.
Bends or twist described above and undue stress to any portion except mounting hole portion may
cause display un-uniformity.
Do not press or rub on the sensitive display surface. If customer clean on the panel surface, NEC
Corporation recommends using the cloth with ethanolic liquid such as screen cleaner for LCD.
Do not bend or unbend the lamp cable at the near part of the lamp holding rubber, to avoid the damage
for high voltage side of the lamp. This damage may cause a lamp breaking and abnormal operation of
high voltage circuit.
Take hold of both ends without touch the circuit board when customer pulls out products (LCD
modules) from inner packing box. If customer touches it, products may be broken down or out of
adjustment, because of stress to mounting parts.
Do not hook cables nor pull connection cables such as flexible cable and so on, for fear of damage.
If customer puts down the product temporarily, the product puts on flat subsoil as a display side turns
down.
Take the measures of electrostatic discharge such as earth band, ionic shower and so on, when
customer deals with the product, because products may be damaged by electrostatic.
The torque for mounting screws must never exceed 0.29N m. Higher torque values might result in
distortion of the bezel.
Do not push-pull the interface connectors while the product is working, because wrong power
sequence may break down the product.
ambient temperature.
they are made of glass. (Shock: To be not greater 539m/s
Pressure: To be not greater 19.6N)
Do not shock and press the LCD panel and the backlight! Danger of breaking, because
Pay attention to burn injury for the working backlight! It may be over 35 C from
wrong operations.
This sign has the meaning that customer will be injured by himself, if customer has
PRELIMINARY DATA SHEET DOD-M-1348 (2nd edition)
2
and to be not greater 11ms,
NL10276BC20-07Y
20
2
2
Datasheet pdf - http://www.DataSheet4U.net/