NL10276BC20_07Y NEC, NL10276BC20_07Y Datasheet - Page 21

• Manufacturer Part Number: NL10276BC20_07Y
• Description: Display Module
• Manufacturer: NEC

www.DataSheet.co.kr
5.3.2 Environment
5.3.3 Characteristics
5.3.4 Other
The following items are neither defects nor failures.
(VDDB) terminals should be used without a non-connected line.
In order to prevent dew condensation occurring by temperature difference, the product packing box
must be opened after leave under the environment of an unpacking room temperature enough.
Because a situation of dew condensation occurring is changed by the environmental temperature and
humidity, evaluate the leaving time sufficiently. (Recommendation leaving time: 6 hour or more with
packing state)
patterns.
Do not operate or store in high temperature, high humidity, dewdrop atmosphere or corrosive gases.
Keep the product in antistatic pouch in room temperature, because of avoidance for dusts and
sunlight, if customer stores the product.
Do not operate in high magnetic field. Circuit boards may be broken down by it.
Use an original protection sheet on the product surface (polarizer). Adhesive type protection sheet
should be avoided, because it may change color or properties of the polarizer.
This product is not designed as radiation hardened.
depending on operating time, and especially low temperature, because the LCD has cold cathode
fluorescent lamps.
saver, if the fixed pattern is displayed on the screen.
backlight.
luminance control frequency of customer's backlight inverter may appear on a display. Set up
luminance control frequency of backlight inverter so that the interference noise does not appear.
backlight lamps.
transportation, when customer returns it to NEC Corporation for repair and so on.
Response time, luminance and color may be changed by ambient temperature.
Optical characteristics may be changed by input signal timings.
Do not disassemble a product or adjust volume without permission of NEC Corporation.
Pay attention not to insert waste materials inside of products, if customer uses screwnails.
The LCD may be seemed luminance non-uniformity, flicker, vertical seam or small spot by display
Do not display the fixed pattern for a long time because it may cause image sticking. Use a screen
The display color may be changed by viewing angle because of the use of condenser sheet in the
All GND, backlight inverter ground (GNDB), VCC and backlight inverter power supply voltage
Pack the product with original shipping package, because of avoidance of some damages during
The interference noise of input signal frequency for this product's signal processing board and
Optical characteristics (e.g. luminance, display uniformity, etc.) gradually is going to change
See "REPLACEMENT MANUAL FOR LAMPHOLDER", if customer would like to replace
PRELIMINARY DATA SHEET DOD-M-1348 (2nd edition)
NL10276BC20-07Y
21
2
2
Datasheet pdf - http://www.DataSheet4U.net/