s908gr16ag4cfj Freescale Semiconductor, Inc, s908gr16ag4cfj Datasheet - Page 120

• Manufacturer Part Number: s908gr16ag4cfj
• Description: M68hc08 Microcontrollers Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

Input/Output (I/O) Ports
12.2.3 Port A Input Pullup Enable Register
The port A input pullup enable register (PTAPUE) contains a software configurable pullup device for each
of the eight port A pins. Each bit is individually configurable and requires that the data direction register,
DDRA, bit be configured as an input. Each pullup is automatically and dynamically disabled when a port
bit’s DDRA is configured for output mode.
PTAPUE7–PTAPUE0 — Port A Input Pullup Enable Bits
12.3 Port B
Port B is an 8-bit special-function port that shares all eight of its pins with the analog-to-digital converter
(ADC) module.
12.3.1 Port B Data Register
The port B data register (PTB) contains a data latch for each of the eight port pins.
PTB7–PTB0 — Port B Data Bits
AD7–AD0 — Analog-to-Digital Input Bits
120
These writable bits are software programmable to enable pullup devices on an input port bit.
These read/write bits are software-programmable. Data direction of each port B pin is under the control
of the corresponding bit in data direction register B. Reset has no effect on port B data.
AD7–AD0 are pins used for the input channels to the analog-to-digital converter module. The channel
select bits in the ADC status and control register define which port B pin will be used as an ADC input
and overrides any control from the port I/O logic by forcing that pin as the input to the analog circuitry.
1 = Corresponding port A pin configured to have internal pullup
0 = Corresponding port A pin has internal pullup disconnected
Alternative
Function:
Address:
Address:
Care must be taken when reading port B while applying analog voltages to
AD7–AD0 pins. If the appropriate ADC channel is not enabled, excessive
current drain may occur if analog voltages are applied to the PTBx/ADx pin,
while PTB is read as a digital input. Those ports not selected as analog
input channels are considered digital I/O ports.
Reset:
Reset:
Read:
Read:
Write:
Write:
Figure 12-5. Port A Input Pullup Enable Register (PTAPUE)
PTAPUE7
$000D
$0001
PTB7
Bit 7
Bit 7
AD7
0
PTAPUE6
Figure 12-6. Port B Data Register (PTB)
PTB6
AD6
6
0
6
MC68HC908GR16A Data Sheet, Rev. 1.0
PTAPUE5
PTB5
AD5
5
0
5
PTAPUE4
NOTE
Unaffected by reset
PTB4
AD4
4
0
4
PTAPUE3
PTB3
AD3
3
0
3
PTAPUE2
PTB2
AD2
2
0
2
PTAPUE1
PTB1
AD1
1
0
1
Freescale Semiconductor
PTAPUE0
PTB0
Bit 0
Bit 0
AD0
0