lan9218i Standard Microsystems Corp., lan9218i Datasheet - Page 15

• Manufacturer Part Number: lan9218i
• Description: Lan9218i High-performance Single-chip 10/100 Ethernet Controller With Hp Auto-mdix And Industrial Temperature Support
• Manufacturer: Standard Microsystems Corp.

High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX and Industrial Temperature Support
Datasheet
SMSC LAN9218i
2.1
Host Data High
Host DataLow
SPEED_SEL
Host Address
PHY External Bias
Read Strobe
Write Strobe
FIFO Select
Chip Select
Interrupt
Request
NAME
Resistor
0
1
NAME
TPO+
TPO-
TPI+
TPI-
Pin List
FIFO_SEL
SYMBOL
D[31:16]
D[15:0]
A[7:1]
100Mbps
nWR
nRD
nCS
IRQ
10Mbps
SPEED
SYMBOL
EXRES1
TPO+
TPO-
TPI+
TPI-
BUFFER
O8/OD8
Table 2.1 Host Bus Interface Signals
Table 2.2 Default Ethernet Settings
TYPE
(PD)
I/O8
I/O8
Table 2.3 LAN Interface Signals
IS
IS
IS
IS
IS
BUFFER
TYPE
AO
AO
AI
AI
AI
DEFAULT ETHERNET SETTINGS
DATASHEET
PINS
16
16
#
7
1
1
1
1
1
Half-Duplex
Half-Duplex
DUPLEX
PINS
NUM
15
1
1
1
1
1
Bi-directional data port.
7-bit Address Port. Used to select Internal CSR’s and
Active low strobe to indicate a read cycle.
When driven high all accesses to the LAN9218i are to
Bi-directional data port.
Note that Pull-down’s are disabled in 32 bit mode.
TX and RX FIFOs.
Active low strobe to indicate a write cycle. This signal,
qualified with nCS, is also used to wakeup the
LAN9218i when it is in a reduced power state.
Active low signal used to qualify read and write
operations. This signal qualified with nWR is also used
to wakeup the LAN9218i when it is in a reduced power
state.
Programmable Interrupt request. Programmable
polarity, source and buffer types.
the RX or TX Data FIFOs. In this mode, the A[7:3]
upper address inputs are ignored.
Transmit Positive Output (normal)
Receive Positive Input (reversed)
Transmit Negative Output (normal)
Receive Negative Input (reversed)
Receive Positive Input (normal)
Transmit Positive Input (reversed)
Receive Negative Input (normal)
Transmit Negative Output (reversed)
Must be connected to ground through a 12.4K
ohm 1% resistor.
DESCRIPTION
DESCRIPTION
AUTO NEG.
Disabled
Enabled
Revision 2.3 (08-06-08)