isd-t360sb ETC-unknow, isd-t360sb Datasheet - Page 76

• Manufacturer Part Number: isd-t360sb
• Manufacturer: ETC-unknow

ISD-T360SB
INIT
Execute this command after the VoiceDSP processor has been configured (see CFG command). INIT
performs a soft reset of the VoiceDSP as follows:
•
•
•
•
•
•
•
The current message is undefined after INIT execution.
The tunable parameters are not affected by this command. They are set to their default values only dur-
ing RESET.
Example
INJ
Injects vocabulary data of size n bytes to good Flash blocks.
This command programs Flash devices, on a production line, with IVS vocabulary data. It is optimized for
speed; all VoiceDSP processor detectors are suspended during execution of the command. Use the
CVOC command to check whether programming was successful.
If there is not enough memory space for the vocabulary data, ERR_PARAM is set in the error word, and
execution stops.
Flash blocks that include IVS data can not be used for recording, even if only one byte of the block con-
tains IVS data (e.g., if the vocabulary size is 4K + 100 bytes, two blocks of the Flash are not available for
message recording).
Example
2-40
INIT
Byte sequence:
Description:
INJ 00000080
Data
Byte sequence:
Description:
Initializes the message directory information.
Messages are not deleted. To delete the messages, use the DM and DMS commands.
Sets the detectors mask to 0.
Sets the volume level that is controlled by the VC command, to 0.
Sets the playback speed to normal (0).
Switches to the IDLE state.
Initializes the tone detectors.
Microcontroller
VoiceDSP
Initialize the VoiceDSP processor.
Microcontroller
VoiceDSP
Inject 128 bytes of vocabulary data.
Initialize System
Inject IVS Data n byte
1
... byte
29
29
00
00
n
00
00
00
00
80
80
Voice Solutions in Silicon™
Vocabulary Data
Echo of Data
2—SOFTWARE
13
13