mb95f204h Fujitsu Microelectronics, Inc., mb95f204h Datasheet - Page 30

• Manufacturer Part Number: mb95f204h
• Description: F2mc-8fx Mb95200h/210h Series
• Manufacturer: Fujitsu Microelectronics, Inc.

30
MB95200H/210H Series
*1: The parameter is based on V
*2: V
*3: Applicable to pins: P00 to P07, P62 to P64, PG1 to PG2, PF0, PF1
*4: P00 to P03, P07, P62 to P64, PG1 to PG2, PF0 and PF1 are available in MB95F204H/F203H/F202H/F204K/
*5: P62 and P63 are available in MB95F204H/F203H/F202H/F204K/F203K/F202K.
WARNING: A semiconductor device may be damaged by applying stress (voltage, current, temperature, etc.) in
to/from an input is limited by means of an external component, the I
• Use under recommended operating conditions.
• Use with DC voltage (current).
• The HV (High Voltage) signal is an input signal exceeding the V
• The value of the limiting resistor should be set to a value at which the current to be input to the microcontroller
• When the microcontroller drive current is low, such as in low power consumption modes, the HV (High Voltage)
• If the HV (High Voltage) signal is input when the microcontroller power supply is off (not fixed at 0 V), since
• If the HV (High Voltage) input is input after power-on, since power is supplied from the pins, the voltage of
• Do not leave the HV (High Voltage) input pin unconnected.
• Example of a recommended circuit :
F203K/F202K.
I
between the HV (High Voltage) signal and the microcontroller before applying the HV (High Voltage) signal.
pin when the HV (High Voltage) signal is input is below the standard value, irrespective of whether the current
is transient current of stationary current.
input potential may pass through the protective diode to increase the potential of the V
devices.
power is supplied from the pins, incomplete operations may be executed.
power supply may not be sufficient to enable a power-on reset.
and V
O
excess of the absolute maximum rating. Therefore, ensure that not a single parameter exceeds its
absolute maximum rating.
must not exceed V
HV(High Voltage) input (0 V to 16 V)
Input/Output Equivalent Circuit
CC
SS
+ 0.3 V. V
= 0.0 V.
I
must not exceed the rated voltage. However, if the maximum current
Limiting
resistor
CC
*4
CLAMP
voltage. Always connect a limiting resistor
rating is used instead of the V
Protective diode
R
V
CC
P-ch
N-ch
CC
pin, affecting other
DS07-12623-1E
I
rating.