sc16c754bibm NXP Semiconductors, sc16c754bibm Datasheet - Page 25

• Manufacturer Part Number: sc16c754bibm
• Description: 5 V, 3.3 V And 2.5 V Quad Uart, 5 Mbit/s Max. With 64-byte Fifos
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 14668
Product data sheet
7.4 Line Control Register (LCR)
This register controls the data communication format. The word length, number of stop
bits, and parity type are selected by writing the appropriate bits to the LCR.
shows the line control register bit settings.
Table 12:
Bit
7
6
5
4
3
2
1:0
Symbol
LCR[7]
LCR[6]
LCR[5]
LCR[4]
LCR[3]
LCR[2]
LCR[1:0]
Line Control Register bits description
5 V, 3.3 V and 2.5 V quad UART, 5 Mbit/s (max.) with 64-byte FIFOs
Description
Divisor latch enable.
Break control bit. When enabled, the Break control bit causes a break
condition to be transmitted (the TX output is forced to a logic 0 state). This
condition exists until disabled by setting LCR[6] to a logic 0.
Set parity. LCR[5] selects the forced parity format (if LCR[3] = 1).
Parity type select.
Parity enable.
Number of stop bits. Specifies the number of stop bits.
Word length bits 1, 0. These two bits specify the word length to be
transmitted or received.
logic 0 = divisor latch disabled (normal default condition)
logic 1 = divisor latch enabled
logic 0 = no TX break condition (normal default condition)
logic 1 = forces the transmitter output (TX) to a logic 0 to alert the
communication terminal to a line break condition
logic 0 = parity is not forced (normal default condition)
LCR[5] = logic 1 and LCR[4] = logic 0: parity bit is forced to a logical 1 for
the transmit and receive data
LCR[5] = logic 1 and LCR[4] = logic 1: parity bit is forced to a logical 0 for
the transmit and receive data
logic 0 = odd parity is generated (if LCR[3] = 1)
logic 1 = even parity is generated (if LCR[3] = 1)
logic 0 = no parity (normal default condition)
logic 1 = a parity bit is generated during transmission and the receiver
checks for received parity
0 = 1 stop bit (word length = 5, 6, 7, 8)
1 = 1.5 stop bits (word length = 5)
1 = 2 stop bits (word length = 6, 7, 8)
00 - 5 bits
01 - 6 bits
10 - 7 bits
11 - 8 bits
Rev. 02 — 13 June 2005
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
SC16C754B
Table 12
25 of 50