wm8569seds-v Wolfson Microelectronics plc, wm8569seds-v Datasheet - Page 21

• Manufacturer Part Number: wm8569seds-v
• Description: 24-bit, 192khz Stereo Codec With Volume Control
• Manufacturer: Wolfson Microelectronics plc

Production Data
POWERDOWN MODES
ZERO DETECT
SOFTWARE CONTROL INTERFACE OPERATION
w
The WM8569 has powerdown control bits allowing specific parts of the WM8569 to be powered off
when not being used. Control bit ADCPD powers off the ADC. The three stereo DACs each have a
separate powerdown control bit, DACPD[2:0] allowing individual stereo DACs to be powered off when
not in use. Setting ADCPD and DACPD[2:0] will powerdown everything except the references VMID
and REFADC. These may be powered down by setting PDWN. Setting PDWN will override all other
powerdown control bits. It is recommended that the ADC and DACs are powered down before setting
PDWN.
The WM8569 has a zero detect circuit for each DAC channel that detects when 1024 consecutive
zero samples have been input. The MUTE pin output may be programmed to output the zero detect
signal which may then be used to control external muting circuits. A ‘1’ on MUTE indicates a zero
detect. The zero detect may also be used to automatically enable DAC mute by setting IZD.
The WM8569 is controlled using a 3-wire serial interface in software mode or pin
programmable in hardware mode.
The control mode is selected by the state of the MODE pin.
3-WIRE (SPI COMPATIBLE) SERIAL CONTROL MODE
SDIN/DM is used for the program data, SCLK/IWL is used to clock in the program data and CSB/IDF
is used to latch the program data. SDIN/DM is sampled on the rising edge of SCLK/IWL. The 3-wire
interface protocol is shown in Figure 20.
Figure 20 3-Wire SPI Compatible Interface
Notes:
1.
2.
3.
B[15:9] are Control Address Bits
B[8:0] are Control Data Bits
CSB/IDF is edge sensitive – the data is latched on the rising edge of CSB/IDF.
PD Rev 4.0 June 2006
WM8569
21