m24lr16e-r STMicroelectronics, m24lr16e-r Datasheet - Page 110

• Manufacturer Part Number: m24lr16e-r
• Description: 16 Kbit Eeprom With Password Protection, Dual Interface & Energy Harvesting 400 Khz I²c Bus & Iso 15693 Rf Protocol At 13.56 Mhz
• Manufacturer: STMicroelectronics

Command codes
110/143
The Response contains:
●
●
Table 92.
During an Inventory process, if the VCD does not receive an RF M24LR16E-R response, it
waits for a time t
edge of the request EOF sent by the VCD.
●
●
where:
●
●
t
modulation mode.
When configured in the RF busy mode, the RF WIP/BUSY pin is driven to 0 from the SOF
starting the inventory command to the end of the M24LR16E-R response.If the M24LR16E-
R does not receive the corresponding slot marker, the RF WIP/BUSY pin remains at 0 till the
next RF power-off.
When configured in the RF write in progress mode, the RF WIP/BUSY pin remains in high-Z
state.
NRT
Response
SOF
the flags,
the Unique ID.
If the VCD sends a 100% modulated EOF, the minimum value of t
t
If the VCD sends a 10% modulated EOF, the minimum value of t
t
t
t
and t
3
3
SOF
NRT
min = 4384/f
min = 4384/f
is the time required by the M24LR16E-R to transmit an SOF to the VCD
is the nominal response time of the M24LR16E-R
SOF
Response
Fast Inventory Initiated response format
are dependent on the M24LR16E-R-to-VCD data rate and subcarrier
_flags
8 bits
3
before sending an EOF to switch to the next slot. t
C
C
(323.3µs) + t
(323.3µs) + t
DSFID
8 bits
Doc ID 018932 Rev 7
SOF
NRT
64 bits
UID
3
3
starts from the rising
CRC16
3
16 bits
is:
is:
M24LR16E
Response
EOF