LUPA-4000 CYPRESS [Cypress Semiconductor], LUPA-4000 Datasheet - Page 32

• Manufacturer Part Number: LUPA-4000
• Description: 4M Pixel CMOS Image Sensor
• Manufacturer: CYPRESS [Cypress Semiconductor]

As soon as Sync_x is high and 1 rising edge of Clock_x occurs, the pixels are brought
to the analog outputs. This is again the simulation result of a comparable sensor to
show the principle.
Please note there is a time difference between the clock edge and the moment the data
is seen at the output. As this time difference is very difficult to predict in advance, it
is advisable to have the ADC sampling clock flexible to set an optimal Adc sampling
point. The time differences can easily vary between 5 – 15nsec and have to be tested
on the real devices.
4.2.2 Reduced Row Overhead Time timing
The row overhead time is the time between the selection of lines that one has to wait
to get the data stable at the column amplifiers.
This row overhead time is a loss in time, which should be reduced as much as
possible.
Figure 17: output signal related to Clock_x signal. From bottom to top: Clock_x, Sync_x and output.
Contact:
Cypress Semiconductor Corporation
LUPA-4000
Data Sheet
The output level before the first pixel is the level of the last pixel of previous line.
[e-mail]
dark
Pixel 1
Document #: 38-05712 Rev.**(Revision 1.2 )
3901 North First Street
Pixel2….: Pixel period : 20nsec
saturated
San Jose, CA 95134
Page 32 of 49
408-943-2600
Clock_x:
25MHz
Output 1
Sync_x