PIC18F2331 MICROCHIP [Microchip Technology], PIC18F2331 Datasheet - Page 267

• Manufacturer Part Number: PIC18F2331
• Description: 28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High Performance PWM and A/D
• Manufacturer: MICROCHIP [Microchip Technology]

21.2.1
The internal reference voltage of the LVD module may
be used by other internal circuitry (the Programmable
Brown-out Reset). If these circuits are disabled (lower
current consumption), the reference voltage circuit
requires a time to become stable before a low-voltage
condition can be reliably detected. This time is invariant
of system clock speed. This start-up time is specified in
electrical specification parameter 36. The low-voltage
interrupt flag will not be enabled until a stable reference
voltage is reached. Refer to the waveform in Figure 21-4.
21.2.2
When the module is enabled, the LVD comparator and
voltage divider are enabled and will consume static
current. The voltage divider can be tapped from
multiple places in the resistor array. Total current
consumption, when enabled, is specified in electrical
specification parameter #D022B.
 2003 Microchip Technology Inc.
REFERENCE VOLTAGE SET POINT
CURRENT CONSUMPTION
PIC18F2331/2431/4331/4431
Preliminary
21.3
When enabled, the LVD circuitry continues to operate
during Sleep. If the device voltage crosses the trip
point, the LVDIF bit will be set and the device will wake-
up from Sleep. Device execution will continue from the
interrupt vector address if interrupts have been globally
enabled.
21.4
A device Reset forces all registers to their Reset state.
This forces the LVD module to be turned off.
Operation During Sleep
Effects of a Reset
DS39616B-page 265