MC68HC908LJ12CPB FREESCALE [Freescale Semiconductor, Inc], MC68HC908LJ12CPB Datasheet - Page 323

• Manufacturer Part Number: MC68HC908LJ12CPB
• Description: 8-bit microcontroller units
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Liquid Crystal Display Driver (LCD)
16.5.4 Fast Charge and Low Current
Technical Data
324
The default value for each of the bias resistors (see
in the resistor ladder is approximately 37kΩ at V
high current drain through the 37kΩ resistor ladder may not be suitable
for some LCD panel connections. Lowering this current is possible by
setting the LC bit in the LCD control register, switching the R
to 146kΩ.
Although the lower current drain is desirable, but in some LCD panel
connections, the higher current is required to drive the capacitive load of
the LCD panel. In most cases, the higher current is only required when
the LCD waveforms change state (the rising and falling edges in the LCD
output waveforms). The fast charge option is designed to have the high
current for the switching and the low current for the steady state. Setting
the FC bit in the LCD control register selects the fast charge option. The
R
LCD waveform switching edge, and then back to 146kΩ for the steady
state period. The duration of the fast charge time is set by configuring the
FCCTL[1:0] bits in the LCD clock register, and can be LCDCLK/32,
LCDCLK/64, or LCDCLK/128.
relative to the BP0 waveform.
LCD
FAST CHARGE CLOCK
value is set to 37kΩ (for high current) for a fraction of time for each
LCD WAVEFORM
EXAMPLE: BP0
Liquid Crystal Display Driver (LCD)
LCDCLK
Figure 16-4. Fast Charge Timing
HIGH CURRENT SELECTED BEFORE SWITCHING EDGE,
PERIOD IS DEFINED BY FCCTL[1:0]
Figure 16-4
shows the fast charge clock
MC68HC908LJ12
LCD
Freescale Semiconductor
Figure
= 3V. The relatively
16-3), R
LCD
—
Rev. 2.1
value
LCD
,