TDA6650ATT NXP [NXP Semiconductors], TDA6650ATT Datasheet - Page 45

• Manufacturer Part Number: TDA6650ATT
• Description: 5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog)
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
13. Application information
TDA6650ATT_6651ATT_2
Product data sheet
13.1 Tuning amplifier
13.2 Crystal oscillator
13.3 Examples of I
The tuning amplifier is capable of driving the varicap voltage without an external transistor.
The tuning voltage output must be connected to an external load of 15 k which is
connected to the tuning voltage supply rail. The loop filter design depends on the oscillator
characteristics and the selected reference frequency as well as the required PLL loop
bandwidth.
Applications with the TDA6650ATT; TDA6651ATT have a large loop bandwidth, in the
order of a few tens of kHz. The calculation of the loop filter elements has to be done for
each application, it depends on the reference frequency and charge pump current.
The TDA6650ATT; TDA6651ATT needs to be used with a 4 MHz crystal in series with a
capacitor with a typical value of 18 pF, connected between pin XTAL1 and pin XTAL2.
Philips crystal 4322 143 04093 is recommended. When choosing a crystal, take care to
select a crystal able to withstand the drive level of the TDA6650ATT; TDA6651ATT without
suffering from accelerated ageing. For optimum performances, it is highly recommended
to connect the 4 MHz crystal without any serial resistance.
The crystal oscillator of the TDA6650ATT; TDA6651ATT should not be driven (forced)
from an external signal. Do not use the signal on pins XTAL1 or XTAL2, or the signal
present on the crystal, to drive an external IC or for any other use as this may dramatically
degrade the phase noise performance of the TDA6650ATT; TDA6651ATT.
Table 21
The following conditions apply:
To fully program the device, either sequence of
other arrangements of the bytes are also possible.
S = START
A = acknowledge
P = STOP.
LO frequency is 800 MHz
f
N = 5600
BS3 output port is on and all other ports are off: thus the high band is selected
Charge pump current I
Normal mode, with XTOUT buffer on
I
AGC take-over point is set to 112 dB V (p-p)
Address selection is adjusted to make address C2 valid.
comp
AGC
= 220 nA
= 142.86 kHz
to
Table 26
2
C-bus program sequences
show various sequences where:
Rev. 02 — 2 February 2007
CP
= 600 A
TDA6650ATT; TDA6651ATT
5 V mixer/oscillator and low noise PLL synthesizer
Table 21
or
Table 22
can be used, while
© NXP B.V. 2007. All rights reserved.
45 of 54