WM9712CLGEFL/RV WOLFSON [Wolfson Microelectronics plc], WM9712CLGEFL/RV Datasheet - Page 37

• Manufacturer Part Number: WM9712CLGEFL/RV
• Manufacturer: WOLFSON [Wolfson Microelectronics plc]

Production Data
w
VARIABLE RATE AUDIO / SAMPLE RATE CONVERSION
By using an AC’97 Rev2.2 compliant audio interface, the WM9712L can record and playback at all
commonly used audio sample rates, and offer full split-rate support (i.e. the DAC, ADC and AUXDAC
sample rates are completely independent of each other – any combination is possible).
The default sample rate is 48kHz. If the VRA bit in register 2Ah is set and the appropriate block is
enabled, then other sample rates can be selected by writing to registers 2Ch, 32h and 2Eh. The AC-
Link continues to run at 48k frames per second irrespective of the sample rate selected. However, if
the sample rate is less than 48kHz, then some frames do not carry an audio sample.
Table 24 Audio Sample Rate Control
REGISTER
ADDRESS
2Ah
Extended
Audio
Stat/Ctrl
2Ch
Audio DAC
Sample Rate
32h
Audio ADC
Sample Rate
2Eh
AUXDAC
Sample Rate
BIT
0
15:0
15:0
15:0
LABEL
VRA
DACSR
ADCSR
AUXDA
CSR
DEFAULT
0 (OFF)
BB80h
(48kHz)
BB80h
(48kHz)
BB80h
(48kHz)
DESCRIPTION
Variable Rate Audio
0: OFF (DAC and ADC run at 48kHz)
1: ON (sample rates determined by
registers 2Ch, 2Eh and 32h)
Audio DAC sample rate
1F40h: 8kHz
2B11h: 11.025kHz
2EE0h: 12kHz
3E80h: 16kHz
5622h: 22.05kHz
5DC0h: 24kHz
7D00h: 32kHz
AC44h: 44.1kHz
BB80h: 48kHz
Any other value defaults to the nearest
supported sample rate
Audio ADC sample rate
similar to DACSR
AUXDAC sample rate
similar to DACSR
PD, Rev 4.6, November 2011
WM9712L
37