MAX9966BGCCQ+TD Maxim Integrated, MAX9966BGCCQ+TD Datasheet - Page 8

• Manufacturer Part Number: MAX9966BGCCQ+TD
• Description: Buffers & Line Drivers
• Manufacturer: Maxim Integrated

Specifications of MAX9966BGCCQ+TD

• Rohs: yes

Quad Low-Power, 500Mbps
ATE Driver/Comparator
8
Note 14: Prop delays are measured from the crossing point of the differential input signals to the 50% point of expected output
Note 15: Rising edge to rising edge or falling edge to falling edge.
Note 16: Specified amplitude is programmed. At this pulse width, the output reaches at least 95% of its nominal (DC) amplitude.
Note 17: Specified amplitude is programmed. Maximum data rate specified in transitions per second. A square wave that reaches
Note 18: Crosstalk from any driver to the other three channels. Aggressor channel is driving 3V
Note 19: Indicative of switching speed from DHV_ or DLV_ to DTV_ and DTV_ to DHV_ or DLV_ when V
Note 20: Change in Offset Voltage over input range.
Note 21: Change in Offset Voltage with power supplies independently set to their minimum and maximum values.
Note 22: Unless otherwise noted, all Prop Delays are measured at 40MHz, V
Note 23: V
Note 24: Relative to propagation delay at V
_______________________________________________________________________________________
swing. Rise time of the differential inputs DATA_ and RCV_ is 250ps (10% to 90%).
The pulse width is measured at DATA_.
at least 95% of its programmed amplitude may be generated at one-half of this frequency.
are in term mode with V
V
Z
V
from V
pulse width is measured at the crossing points of the differential outputs.
DTV_
S
CCO_ _
DUT_
= 50Ω, driver in Term Mode with V
< V
DUT_
= 0 to 1V, V
= 2V. Open-collector outputs are also terminated (internally or externally) with R
DLV_
crossing calibrated CHV_/CLV_ threshold to crossing point of differential outputs.
or V
CHV_
DTV_
DTV_
= V
> V
CLV_
DHV_
= 1.5V.
= 0.5V. At this pulse width, the output reaches at least 90% of its DC Voltage swing. The
, switching speed is degraded by approximately a factor of 3.
CHV_
DTV_
= V
= 0V. Comparator outputs are terminated with 50Ω to GND at scope input with
CLV_
= 1.5V. V
DUT_
= 200mV
DUT_
P-P
= 0 to 2V, V
. Overdrive = 100mV.
CHV_
P-P
TERM
into a 50Ω load. Victim channels
= V
CLV_
DLV_
= 50Ω to V
= 1V, slew rate = 2V/ns,
< V
DTV_
CCO_ _
< V
DHV_
. Measured
. If