M29W128GSL70ZS6E NUMONYX, M29W128GSL70ZS6E Datasheet - Page 28

• Manufacturer Part Number: M29W128GSL70ZS6E
• Description: IC FLASH 128MBIT 70NS 64FBGA
• Manufacturer: NUMONYX
• Series: Axcell™r

Specifications of M29W128GSL70ZS6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 128M (16Mx8, 8Mx16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Command interface
7.1.10
28/85
Program command
The Program command can be used to program a value to one address in the memory array
at a time. The command requires four bus write operations, the final write operation latches
the address and data in the internal state machine and starts the program/erase controller.
Programming can be suspended and then resumed by issuing a Program Suspend
command and a Program Resume command, respectively (see
Suspend command
If the address falls in a protected block then the Program command is ignored, the data
remains unchanged. The status register is never read and no error condition is given.
After programming has started, bus read operations output the status register content (bus
reading operations from banks different from those including the block being programmed,
output the memory array content). See
waveforms
times and program, erase endurance
After the program operation has completed the memory will return to the read mode, unless
an error has occurred. When an error occurs, bus read operations to the memory continue
to output the status register. A Read/Reset command must be issued to reset the error
condition and return to read mode.
One of the erase commands must be used to set all the bits in a block or in the whole
memory from ’0’ to ’1’.
The program operation is aborted by performing a reset or powering-down the device. In this
case data integrity cannot be ensured, and it is recommended to reprogram the word or byte
aborted.
for more details. Typical program times are given in
and
Section 7.1.9: Program Resume
cycles.
Figure 15: Write enable controlled program
command).
Table 12: Program, erase
Section 7.1.8: Program
M29DW128G